Blaupunkt RD 148 Clock, Setting the clock, Switching DCF 77 on/off, Automatically

Page 22

Press DSC.

Press / as many times as required until “CD UPD” appears on the display panel.

Press >> to select “CLR DISC” if you want to delete the name of that CD,

or

Press << to select “CLR ALL” to delete the names stored for all of the CDs.

Press for approximately 2 seconds. “UPDATE” will appear briefly in the display. The deletion process is complete.

To quit this function:

Press DSC.

Clock

This car stereo is equipped with a built-in clock which automatically takes advantage either of RDS or the DCF 77 signal (control signal for atomic clocks, used in special cas- es), to ensure highly accurate time-keeping (hours, minutes).

For the clock to function properly with RDS, an RDS station with the CT function (CT – clock time) must be received.

The automatic correction of the time or just the hours using DCF 77 can be switched off.

Switching DCF 77 on/off:

Press DSC for approximately 2 sec- onds.

If the display shows “DCF77 ON”, DCF 77 is active.

If the display shows “NO DCF77”, DCF 77 is inactive.

Setting the clock

a)automatically

The clock is set automatically when the radio is tuned into an RDS station which has the “CT” function (clock time).

If the RDS signal is not received for a week, the radio will attempt to use

DCF 77 to adjust the clock to the cor- rect time the next time the radio is switched off.

Condition: DCF 77 is switched on.

“CLK SYNC” will appear in the display for 20 seconds and you will hear a melody (Big Ben) to indicate that the radio is still active and that the power antenna (if connected) is still extend- ed.

If it is not possible to receive the DCF 77 signal, the radio will switch off after a few seconds.

b)manually with DSC-CLOCKSET

Press DSC briefly, “CLOCKSET” will appear in the display.

Press << >> to set the hours/min- utes. You can move to a different position by pressing /.

After you have set the clock, press briefly to store the new setting.

PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH DEUTSCH

49

Image 22
Contents Modena RD Page Contents Quick reference AUD a DSC Mode @ PTY? Flashing KeyCard tongue DisplayInsert KeyCard BNDRPT Repeat 3, 4, 5, 6 preset buttons Radio operationII Pause MIXSwitching AUD off Adjusts the treble and bass frequen- ciesSetting the Balance left/right and the fader front/rear AUDImportant notes What you need to know Installation AccessoriesTraffic safety Telephone muteOperating the unit KeyCard theft protection systemRemoving the KeyCard Turn On Message T.O.M Displaying the radio pass dataShort Additional Memory S.A.M Optical indication for extra theft protectionAF Alternative frequency REG regional programmeManual tuning with Station tuningAutomatic tuning Selecting a wavebandTo start Preset Scan Switching between the memory banks FMScanning stored stations with Preset Scan Storing stationsSwitching from stereo to mono Selecting the seek tuning sensi- tivityAdjusting the bandwidth FM Changing the scan timeNews Programme typeWeather Finance Scanning stations with PTY Scan Storing programme typesPTY priority Traffic programme station reception with RDS-EON Traffic announcement priority on/offAutomatic seek tuning start Switching the warning beep offCD operation Entering CD names Selecting the display modeDeleting CD names with DSC Update To stop the Scan functionClock Setting the clockSwitching DCF 77 on/off AutomaticallyDisplaying the clock Correcting the clock after the power has been disconnectedDeactivating the hour correction function Setting the equaliser Setting recommendations on the InternetLower mid-range Assistance in setting your equaliserFrequency range Sound impression / Problem What to do Bass Mid-range soundDSC programming LishLearn KC To train a second Key- Card STEREO/MONOOverview of the DSC factory settings Tuner SpecificationsAmplifier CD playerBosch Gruppe