Displaying the clock

You can set the clock to permanent display in both the radio and CD modes.

If another function is selected, the clock dis- play will disappear for approximately 8 sec- onds and the station selected, for example, will appear in the display.

To switch the display mode:

•Press LD for approximately 2 seconds.

Correcting the clock after the power has been disconnected

If the radio has been disconnected from its power source for a longer period of time, “0:00” will appear in the display when it is re-connected.

The time will be set automatically by RDS- CT, but can also be adjusted manually if desired.

You need only set the time manually if it is not possible to receive an RDS station with CT (clock time).

Deactivating the hour correction function

In the DSC menu it is possible to switch off the hour correction function with “CLK MAN/ CLK AUTO”. An automatic correction for minutes will continue to take place.

This is useful if you would like to display the time for a different time zone, for example.

If necessary,

•Press DSC briefly and

•Press / as often as required until “CLK MAN/CLK AUTO” appears in the display.

To deactivate the hour correction function press << >> to select “CLK MAN”.

•Press << >> to set the hours/minutes.

Warning note

Danger of damaging the automatic power antenna in a car wash

If your vehicle is equipped with an automat- ic power antenna, it might still remain fully extended after you have turned the radio off in order to synchronise the time with DCF 77.

Before you drive into a car wash

•switch the radio off by pressing the ON button.

The power antenna will retract, if it doesn’t, press ON again.

DCF 77 will remain inactive for as long as the radio is switched off.

Do not drive into the car wash unless the power antenna has retracted!

After you leave the car wash “DCF 77” will reactivate when you switch the radio on again.