Station tuning
Automatic tuning 
/
•Press 
/
; the car radio will automati- cally search for the next station.
When keeping the upper or lower part 
/
of the rocker switch depressed, seek tuning will speed up in upwards or downwards di- rection.
Manual tuning:
•Press << >>. The frequency will change in short intervals in downwards or upwards direction.
When holding the right or left part of the rock- er switch depressed, the frequency scan is speeded up.
Scrolling through the broadcast- ing networks
Changing the memory bank
You can shift between the memory banks I,
IIand T in order to store stations and recall them later.
The currently selected memory bank is in- dicated in the display.
• Press the TS/FM or TS/BND button as many times until the desired memory bank lights up in the display.
Seek tuning
Up
Down
<</ >> Up/Down in short intervals
(FM only, “AF” must be switched off)
Manual tuning with << >>
You can also tune in a station manually.
Condition:
AF must be switched off (i.e. the symbol does not light up in the display).
If necessary, deactivate AF:
•Press AF/TA for about 1 second.
You can use the << >> buttons to tune in stations of your reception area.
If several programmes of the broadcasting networks can be received, you can scroll through them in forwards direction pressing >>, or backwards using the << button, e.g. NDR 1, 2, 3, 4,
For this it is necessary that the stations have been tuned in at least once and that “AF” is active (lights up in the display).
For this purpose, start automatic tuning, e.g. using Travelstore:
•Press TS/FM or TS/BND for 1 sec.; the system starts to run through the fre- quency band. The display shows “T- STORE”.
If “AF” does not light up,
•press AF/TA for approximately 1 sec. This fulfils the requirements for selecting stations with << >>.
Storing stations
On FM, you can store five stations on the preset buttons 1, 2, 3, 4, 5 for each of the memory banks I, II and T.
On MW/LW, you can also store five stations each (only with Verona RCR 127).
•Select the desired memory bank.
•Tune in a station with the rocker switch (either automatically or manually).
•Press and hold down the desired pre- set button until the radio resumes play after the muting (takes approximately 1 sec., confirmed by beep).
Now the station has been stored.
The activated preset button is indicated in the display.
28