02Tuner
Listening to the radio
1 2 3
4
These are the basic steps necessary to operate the radio. More advanced tuner operation is explained starting on page 12.
Important
If you are using this unit in North, Central or South America, reset the AM tuning step (see Setting the AM tuning step on page 31).
1STEREO (ST) indicator
Shows that the frequency selected is being broadcast in stereo.
2BAND indicator
Shows which band the radio is tuned to, AM or FM.
3PRESET NUMBER indicator
Shows what preset has been selected.
4FREQUENCY indicator
Shows to which frequency the tuner is tuned.
1 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
2Use VOLUME to adjust the sound level. Rotate to increase or decrease the volume.
3Press BAND/ESC to select a band.
Press BAND/ESC until the desired band is dis- played, FM1, FM2, FM3 for FM or AM.
Section
03
4 To perform manual tuning, press 2 or 3 |
| |
with quick presses. | English | |
The frequencies move up or down step by step. | ||
| ||
5 To perform seek tuning, press and hold 2 |
| |
or 3 for about one second and release. |
| |
The tuner will scan the frequencies until a |
| |
broadcast strong enough for good reception is |
| |
found. | Español | |
• You can cancel seek tuning by pressing either | ||
| ||
2 or 3 with a quick press. |
| |
• If you press and hold 2 or 3 you can skip |
| |
broadcasting stations. Seek tuning starts as |
| |
soon as you release the buttons. |
| |
Note | Deutsch | |
• When the frequency selected is being broad- | ||
| ||
cast in stereo the STEREO (ST ) indicator will |
| |
light. |
| |
| Français | |
| Italiano | |
| Nederlands |
En 11
