Blaupunkt RCR 126 operating instructions Automatic tuning, Manual tuning

Page 10
23
Should you tune in a station which has alrea- dy been stored before, the corresponding preset button and the memory bank will briefly flash in the display if you have selected another memory bank.
Notice:
Storing stations
You can use the << >> buttons to tune in stations of your reception area.
If several programmes of one broadcasting network can be received, you can scroll
through them in forwards direction pressing
>>, or backwards using the << button, e.g. On FM, you can store six stations on the NDR 1, 2, 3, 4, N-JOY (North German broad- preset buttons 1 to 6 for each of the memory
caster).banks I, II and T.
For this it is necessary that the stations have • Select the desired memory bank. been received at least once and that “AF” has • Tune in a station with the rocker switch
been activated before (lights up in the dis- (either automatically or manually).
play).• Press the desired preset button until
For this purpose, you may start Travelstore the radio resumes play after the muting
seek operation:(takes approximately 2 seconds, confir-
• Press TS for 2 seconds; the system med by beep).
starts to run through the frequency Now the station has been stored.
band.The activated preset button is indicated in the
If “AF” does not light up,display.
• press AF.
With this, the requirements for selecting sta- tions with << >> are fulfilled.
Scrolling through the broad- casting network (only FM)
You can shift between the memory banks I, II, and T to store and recall preset stations. The selected memory bank is indicated in the display.
• Press FM or TS until the desired me-
mory bank lights up in the display (press repeatedly if necessary).
Changing the memory bank

• Press the REG button briefly.When holding the right or left part of the When active, “REG ON” will be briefly dis- rocker switch pressed down, the frequency

played each time the radio is switched on.

scan is speeded up.

Automatic tuning /

Press /; the car radio will automati-

cally search for the next station.

When keeping the upper or lower part / of the rocker switch depressed, seek tuning will speed up in upwards or downwards direc- tion.

Automatic tuning

Up

Down

/ Up/down in short intervals (“AF” must be switched off)

/ To scroll through the broadcasting network when “AF” is activated (e.g. NDR1 ... NDR4).

Manual tuning << >>

(prerequisite: AF is switched off!)

Press << >>; the frequency will change in short intervals in downwards or up- wards direction.

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

Image 10
Contents Trier RCR Page Contents Adjusted value is indicated On Off VolumeTo alter a setting Short instructionsRadio operation Lo/dxCassette loading slot = PS 3, 4, 5, 6 preset buttonsProg button/Fast winding You can store six stations on each FM memory bank I, II, TRocker switch Seek tuning Precautions Installation/ConnectionTraffic safety DSC modePutting the unit into operation Removing the KeyCard KeyCard theft-protection systemDefining a second KeyCard/ Replacing a KeyCard REG regional programme Radio operation with RDS Radio Data SystemAF Alternative frequency Manual tuning Automatic tuningAutomatic tuning Sampling stored stations briefly Preset Scan Selecting the seek tuning sensi- tivitySwitching from stereo to mono FM Automatically storing the stronTo switch the warning beep off, proceed as described above Automatic seek tuning startThis volume was preset at the factory Fast Forward/Rewind Tape operationInserting a tape Prog selectorDSC programming Appendix Overview of the DSC factory settingsSpecifications Care notesBlaupunkt-Werke GmbH
Related manuals
Manual 18 pages 20.6 Kb