Blaupunkt RCR 126 operating instructions Short instructions, On Off Volume, To alter a setting

Page 4

Short instructions

1On Off Volume

This unit can also be switched on and off with the KeyCard B.

Also, when being connected correctly, you may turn the radio on and off via the ignition of your car.

Use one of the following possibilities to continue operating the set when the ignition is switched off:

a)Switch on/off with knob 1.

b)Remove/insert the KeyCard.

c)Press AUD 3.

When turning on the unit with the Key- Card or by pressing the AUD button, the system will start to play with the volume adjusted last.

When operating the unit with the igniti- on being switched off, the system will automatically shut down after one hour in order to avoid that the battery goes flat.

2LD

Loudness - When listening at a low level, the Loudness function creates a more natural sound by boosting the low frequency range.

To switch the Loudness on/off: Press LD.

For more information, read chapter “DSC programming”.

3AUD/GEO AUD –

To adjust the treble and bass frequen- cies with the rocker switch.

Treble +

Treble

Bass

Bass +

GEO –

 

DEUTSCH

 

 

To adjust the balance (left/right) and

 

 

fader (front/rear) with the rocker switch.

 

 

 

ENGLISH

 

 

 

 

 

 

 

 

Fader front

FRANÇAIS

 

Fader rear

 

Balance left

 

Balance right

ITALIANO

To alter a setting,

 

• press AUD or GEO and then chan-

 

ge the value with the rocker switch.

 

 

NEDERLANDS

The adjusted value is indicated in the

 

display.

 

The last setting will be stored automati-

 

cally.

 

 

To finish the setting: Press AUD or

SVENSKA

GEO.

 

If the setting remains unchanged within

 

8 seconds, the display will switch back

 

to the previous condition.

 

ESPAÑOL

 

 

 

 

 

 

 

 

 

 

PORTUGUÊS

 

 

 

17

Image 4
Contents Trier RCR Page Contents On Off Volume To alter a settingAdjusted value is indicated Short instructionsRadio operation Lo/dxCassette loading slot 3, 4, 5, 6 preset buttons Prog button/Fast winding= PS You can store six stations on each FM memory bank I, II, TPrecautions Installation/Connection Traffic safetyRocker switch Seek tuning DSC modePutting the unit into operation Removing the KeyCard KeyCard theft-protection systemDefining a second KeyCard/ Replacing a KeyCard REG regional programme Radio operation with RDS Radio Data SystemAF Alternative frequency Manual tuning Automatic tuningAutomatic tuning Selecting the seek tuning sensi- tivity Switching from stereo to mono FMSampling stored stations briefly Preset Scan Automatically storing the stronTo switch the warning beep off, proceed as described above Automatic seek tuning startThis volume was preset at the factory Tape operation Inserting a tapeFast Forward/Rewind Prog selectorDSC programming Overview of the DSC factory settings SpecificationsAppendix Care notesBlaupunkt-Werke GmbH
Related manuals
Manual 18 pages 20.6 Kb