Sanyo PLC-WM5500 Computer Input Auto PC Adjustment, Direct Operation, Menu Operation, Note

Computer Input

Auto PC Adjustment

Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Position H and Position V to conform to your computer.

Direct Operation

The Auto PC adjustment function can be operated directly by pressing the AUTO PC button on the remote control.

	Menu Operation
	Auto PC adj..
1	Press the MENU button to display the On-Screen Menu. Use
	the Point ▲▼ buttons to select PC adjust and then press

the Point ► or the SELECT button.

2	Use the Point ▲▼ buttons to select Auto PC adj.. and then
	press the SELECT button.

To store the adjusted parameters..

The adjusted parameters from the Auto PC Adjustment can be stored in the projector. Once the parameters are stored, the setting can be done just by selecting Mode in PC SYSTEM Menu (p.36). See “Manual PC Adjustment” on pages 38-39.

Note:

•Fine sync, Total dots, Position H and Position V of certain computers cannot be fully adjusted with the Auto PC Adjustment function. When the image is not provided properly with this operation, manual adjustments are required. (pp.38-39)

•The Auto PC adjustment cannot be operated when 480i, 575i, 480p, 575p, 720p, 1035i, 1080i or 1080p is selected in the PC System Menu (p.36), or when the signal is coming from the HDMI terminal.

•Depending on the condition of signals and the type and length of cables, the signals may not be properly viewed.

Remote Control

AUTO PC button

PC adjust Menu

Auto PC adj.
Fine sync	0
Total dots	1366
Position H	0
Position V	0
Current mode
Clamp	0
Display area H	1024
Display area V	768
Reset
Mode free
Store

Use the Point ▲▼ buttons to select Auto PC adj.. and press the SELECT button.

Please wait.... . appears while the Auto PC

adjustment is in process.

37