Setting
Setting
This projector has a Setting menu that allows you to set up the other various functions described below.
1 | Press the MENU button to display the |
| Press the Point ▲▼ buttons to select Setting and press the |
| Point ► or the SELECT button to access the submenu items. |
2 | Use the Point ▲▼ buttons to select the desired item and |
| then press the Point ► or the SELECT button to access the |
| selected item. |
3 | Use the Point ▲▼ buttons to select the desired item and |
| then press the SELECT button. |
Language
The language used in the
Menu position
This function is used to change the position of the
The Menu position changes each time you press the SELECT button as follows.
the top left the top right the center the bottom left the bottom right the top left .....
Setting Menu
Language
Input button
This function detects the input signal automatically. When a signal is found, the search will stop. Use the Point ▲▼ buttons to select one of the following options.
Mode 1......Input search will dose not work.
Mode 2......Input search works under the following situation:
–When pressing the INPUT button on the side control. or the remote control.
Mode 3......Input search works under the following situation:
–When turning on the projector by pressing the ON/
–When pressing the INPUT button on the remote control or on the side control.
–When no signal is detected.
Note:
•While Input button is set to Mode 3, and no signal is detected, if the Shutter or Freeze function is active, cancel it to activate the Input search.
•While Input button is set to Mode 1 or Mode 2, the status of Input and Lamp are displayed every time the signal is switched.
•Only the last selected input source can be detected.
•If the INPUT, INPUT 1, INPUT 2, INPUT 3, ON / STAND- BY or MENU button is pressed during Input search is
in progress, Input search will stop and go back to the previous input signal.
51
