Sanyo WM5500L Setting, Note, To change the code for the projector, Simple mode buttons

Setting

Filter control Filter control

You can replace the filter with this function. Press the SELECT button at Filter control to display a confirmation box. To replace, press the SELECT button at Yes and the electrically operated filter starts to scroll.

Note:

•Filter replacement icon and Please wait... message appear on the screen when the filter is being scrolled.

•The filter cannot be rewound.

•When the filter is replaced, the total accumulated time of the filter use is automatically set to 0.

Fan control

Choose the running speed of cooling fans from the following options. Normal...... Operate in this mode under normal conditions.

Max............ Use this mode when you want to increase the cooling

effect when operating the projector in high ambient temperature environment. Fan noise is louder than Normal.

A confirmation box appears and then select Yes.

Simple mode

This function decides whether to activate the simple mode.

Off . . Simple mode function is off.

On . . Only the simple mode buttons are active.

Note:

Warning icon and Simple mode : On message appear on the screen when press the button which is not the simple mode button.

Remote control

The eight different remote control codes (Code 1-Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).

The same code should be set on both the projector and the remote control. For example, operating the projector in Code 7, the remote control code also must be switched to Code 7.

To change the code for the projector

Select a remote control code in this Setting Menu.

To change the code for the remote control:

Press and hold the MENU button and a number button (1-8) on the remote control for more than five seconds to switch between the codes. See “Remote Control Code” on page 16.

Note:

•When different codes are set on the projector and on the remote control, any operation cannot be made. In that case, switch the code on the remote control to fit the code on the projector.

•If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.

Simple mode buttons

Only these buttons are active when the simple mode is set to On. [ON, STAND-BY, INPUT, AUTO PC, INFO.,

MENU, SCREEN, SHUTTER,

▲▼◄►, SELECT, VOL.+,

VOL.-, MUTE, RESET/ON/ ALL-OFF switch] Number buttons (p.14) also become active only when setting the remote control codes numbers or entering the PIN code numbers (pp. 54, 62).

58