Automatically storing the stron, Radio-Scan

Automatically storing the stron-	•	Press PS.
gest stations with Travelstore		The radio will briefly play all the stored
You can automatically store the six most		stations one after another.
	The system will sample the stations of one of
powerful FM stations of your current recepti-
	the memory banks I, II, or T, depending on
on area sorted according to their signal
	which bank was selected before. Free preset
strength. This function is particularly conve-
	buttons will be skipped.
nient on longer trips.
	To switch off Preset Scan:
• Press the TS button for more than
	•	Press PS once again.
2 seconds.
		The radio will continue to play the cur-
The radio will search for the strongest FM
		rently sampled station..
stations and store them on the memory bank

T (Travelstore). When this process has been	Scanning stations with
completed, the radio will play the first station.
If desired, stations can also be stored manu-	Radio-Scan

ally on the Travelstore bank (see “Storing Beginning with the station currently tuned in,
stations”).	you can scan the waveband. The radio will

	play each station for 8 seconds.

Selecting the seek tuning sensi- tivity

You can alter the automatic seek tuning sensitivity.

If “lo” is displayed, the radio will only pick up strong, local stations (low sensitivity).

If “lo” does not light up, the radio will also pick up weaker, distant stations (high sensitivity). To switch over,

•Press lo or dx.

On top of this, the sensitivity levels can be adjusted separately for lo and dx (see chap- ter “DSC programming”).

Switching from stereo to mono (FM)

If reception is poor, you may get better sound

Recalling stored stations

You can recall any stored station by pressing the corresponding preset button.

•Select the waveband using FM or TS.

•Briefly press the corresponding preset button.

Sampling stored stations briefly (Preset Scan)

With this function you can briefly sample all PS stations.

To start the scan:

•Press SC briefly.

The scanned frequency or the station name will start flashing in the display. During the actual scanning process “SCAN” will be displayed.

To select a station currently being scan- ned and switch off the scan function:

•Press SC briefly.

If no station is selected, the scan function will be automatically switched off after the fre- quency band has been run through comple- tely. The unit will tune in the station listened to before starting the scan.

quality by switching to mono:

•Press the lo button for approximately 2 seconds.

With mono playback, the stereo sign will disappear from the display.

Each time the radio is switched on, stereo playback is activated.

The unit will automatically switch to mono if the received signal is not strong enough for stereo playback.