Blaupunkt RCM 85 operating instructions DSC programming, Local, Dis, Beep, Loud

DSC programming

DSC (Direct Software Control) allows you to customise certain programmable, basic set- tings to suit your personal needs and prefe- rences and then store them.

The basic settings for this audio equipment were made at the factory. In the following you can find an overview of these settings, so that you can always reset to these if desired.

If you wish to alter any of the programming,

•press DSC.

The display will show you the adjusted con- dition.

Use the rocker switch to select and adjust the functions described in the following.

/ Select function

Adjust value –

Adjust value +

LOCAL	(lo)
	To adjust the seek tuning
	sensitivity for local recepti-
	on.
	LOCAL 1	- high sensitivity
	LOCAL 3	- low sensitivity

DIS	(dx)
	To adjust the seek tuning
	sensitivity for distant recep-
	tion.
	DIS. 1	- high sensitivity
	DIS. 3	- low sensitivity

TIME ON/OFF To select the display mode during CD changer opera- tion (option).

TIME ON - display of title and playback time.

TIME OFF - display of CD and title number.

If SCAN or MIX is active, the system will always switch to the TIME OFF mode.

TA VOL To adjust the traffic an- nouncement volume from between 1 to 9. The mes- sage will then come through at this volume. (1 = low)

BEEP	Confirmation tone for all
	functions which require a
	button to be pressed for
	more than 2 seconds.
	The volume can be adju-
	sted from between 0 to 9.
	(0 = off)
	Each alteration of this value
	is confirmed by a beep tone
	of the corresponding volu-
	me.
LED (code)	You can adjust the LED C
	to flash for extra anti-theft
	protection.
	LED 1 -	LED always flash-
		es when the unit
		has been swit-
		ched off via the
		ignition.
	LED 0 -	No flashing.
LOUD	Loudness - When listening
	at a low level, the Loud-
	ness function creates a
	more natural sound by

boosting the low frequency range.

LOUD 1 - Low boost LOUD 6 - Max. boost

32