Blaupunkt RCM 85 Receiving traffic programme stations with RDS-EON, Switching from stereo to mono

If the priority for traffic announcement pro- grammes is activated, “TA” will light up in the display.

To switch the priority on or off:

• Press the TA button.

When pressing TA while a message is being broadcast, this message will be interrupted. The unit will then switch back to the previous condition. The priority for other traffic messa- ges remains active.

Traffic announcement priority on/off

Selecting the seek tuning sensi- tivity

Receiving traffic programme stations with RDS-EON

Many FM broadcasters offer traffic messa- ges for their service area at regular intervals.

DEUTSCH

You can alter the automatic seek tuning

All traffic programme stations transmit a spe-

sensitivity.

cial carrier signal alongside their program- mes, which is decoded by your car radio. If

If “lo” is displayed, the radio will only pick up

strong, local stations (low sensitivity).

this signal is identified, “TP” will appear in the display (Traffic Programme).

If “lo” does not light up, the radio will also pick

In addition to these, there are also stations

up weaker, distant stations (high sensitivity).

To switch over,

which do not actually transmit traffic pro-

• Press lo.

grammes themselves, but by using RDS- EON they offer the possibility to receive the

The degree of sensitivity can be altered in

traffic messages broadcast by another traffic both modes (see also chapter “DSC pro- programme station in the same radio net- gramming”).

work. If you listen to one of these stations

Switching from stereo to mono	(e.g. NDR3), “TP” will appear in the display Warning beep
	provided the priority for traffic programme	If you leave the reception area of the traffic
(FM)
	stations has been activated, i.e. “TA” must be programme station currently tuned into, you
If reception is poor, you may get better sound	displayed.	will hear a warning beep after approximately
	If a traffic announcement is broadcast, the
quality by switching to mono:		30 seconds.
	radio will automatically switch to the linked
• Press the lo button for approximately 2		This alarm tone will also be released when
	traffic programme station (in this case, NDR2)
seconds.		pressing a preset button which has no traffic
	for the duration of the message and return to
With mono playback, the stereo sign		programme allocated to it.
	the original programme (NDR3) afterwards.
will disappear from the display.
Each time the radio is switched on, stereo		Switching the warning beep off
playback is activated.		a) Tune into another station offering traffic
The unit will automatically switch to mono if		information:
the received signal is not strong enough for		• Press the rocker switch or
stereo playback.		• a preset button which has a traffic
		programme station allocated to it.
		Alternatively:

ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

29