APC AP9606 manual Events are generated by all UPS models

Events Menu

Management Card and Device Events continued

UPS events	The following table identifies all of the UPS events. However, not all of
	the events are generated by all UPS models.
	Code	Severity	Description
	0x0101	Informational	UPS: Communications established.
	0x0102	Severe	UPS: Communications lost.
	0x0103	Severe	UPS: Sensed a load greater than 100 percent of rated
			capacity.
	0x0104	Informational	UPS: Overload condition cleared.
	0x0105	Informational	UPS: Passed internal self-test.
	0x0106	Severe	UPS: Failed internal diagnostic self-test.
	0x0107	Severe	UPS: Batteries discharged.
	0x0108	Informational	UPS: Battery discharge condition cleared.
	0x0109	Warning	UPS: Switched to battery backup power; utility power
			failure.
	0x010A	Informational	UPS: Returned from battery backup power; utility power
			restored.
	0x010B	Warning	UPS: Enabled SmartBoost; low incoming line voltage.
	0x010C	Informational	UPS: Returned from SmartBoost.
	0x010D	Warning	UPS: Enabled SmartTrim; high incoming line voltage.
	0x010E	Informational	UPS: Returned from SmartTrim.
	0x010F	Severe	UPS: Battery power is low and will soon be exhausted.
	0x0110	Informational	UPS: Returned from a Low-Battery condition.
	0x0113	Informational	UPS: Turned on.
	0x0114	Warning	UPS: Turned off.
	0x0115	Warning	UPS: Entered sleep mode.
	0x0116	Informational	UPS: Returned from sleep mode.
	0x0117	Warning	UPS: Started reboot sequence.
	0x0119	Severe	UPS: Batteries need immediate replacement.
	0x011A	Informational	UPS: Bad battery condition cleared.
	0x011B	Severe	UPS: In bypass due to an internal fault.
	0x011C	Warning	UPS: In bypass due to user command via software or panel.
	0x011D	Warning	UPS: In bypass initiated by user. (The bypass switch at the
			UPS was used.)
	0x011E	Informational	UPS: Returned from bypass.
	0x011F	Severe	UPS: Base module bypass power supply failure.

Continued on next page

Web/SNMP Management SmartSlot Card User’s Guide 62