Web/SNMP Management SmartSlot Card User’s Guide 12
Introduction
Front Panel
Features The front panel has the following features:
• Reset button
• 10Base-T network cable connector
• Link-RX/TX LED
•Status LED
Reset Button. Allows you to reset the Management Card while power
is on.
10Base-T Port. Used to connect the Management Card to the Ethernet
network.
Link-RX/TX LED. Indicates the network status.
Status LED. Indicates the status of the Management Card.
Condition Description
Off The device which connects the Management Card to the network is
turned off or it is not operating correctly.
Flashing The Management Card is receiving data packets from the network.
Condition Description
Off The Management Card has no power.
Solid Green The Management Card has valid network settings.
Flashing Green The Management Card does not have valid TCP/IP settings.1
Solid Red A hardware failure has been detected in the Management Card.
Contact APC Technical Support as described in APC W orldwide
Technical Support on page 74.
Flashing Red The Management Card is making BOOTP requests . If y ou do n ot
use a BOOTP server, you need to configure the Management
Card’s TCP/IP settings.1
1 For information about how to configure the three TCP/IP settings that the
Management Card needs to operate on the network, see the Web/SNMP
Management SmartSlot Card Installation and Quick Start Manual provided in
printed format, and in PDF format on the APC Web/SNMP Ma nagemen t Card utility
CD (.\doc\Insguide.pdf).