Web/SNMP Management SmartSlot Card User’s Guide 29
Network Menu
Option Settings continued
SNMP An Access option (the Settings option in the Control Console) enables
(by default) or disables SNMP. When SNMP is enabled, the Access

Control settings allow you to control how each of the four available

SNMP channels is used.Note: For information about how to define up to four NMSs which will
server as trap receivers, see Trap receivers on page 55; for
more information about how to use SNMP to manage a UPS or an Environmental Monitoring SmartSlot Card, see the PowerNet MIB Reference Guide on the APC Web/SNMP Management Card utility CD (.\doc\mibguide.pdf).
Setting Definition
Community
Name This setting defines the password (maximum of 15 characters)
which an NMS that is defined by the NMS IP setting below uses to
access the channel.
NMS IP Limits access to the N MS or NMSs specified by the format use d for
the IP address. For example:
•159.215.12.1 allows only the NMS with that specific IP address to
have access.
•159.215.12.255 allows access for any NMS on the 159.215.12
segment.
•159.215.255.255 allows access for any NMS on the 159.215
segment.
•159.255.255.255 allows access for any NMS on the 159 segment.
•0.0.0.0 or 255.255.255.255 allows access fo r any NMS.
Access Type Selects how the NMS defined by the NMS IP setting can use the
channel, when that NMS uses the correct Community Name.
Read The NMS can use GETs at any time, but it can never
use SETs.
Write The NMS can use GETs at any time, and can use SETs
when no one is logged into either the Control Console
or Web interface.
Write+ The NMS can use GETs and SETs at any time.
Disabled The NMS cannot use GETs or SETs.