Blaupunkt RCR 148 Receiving traffic programme stations with RDS-EON, On/off, Beep tone

Page 18

Receiving traffic programme stations with RDS-EON

The abbreviation “EON” stands for En-

Traffic announcement priority

hanced Other Networks, meaning the ex-

on/off

change of information within a radio network.

If the priority for traffic announcement pro-

Many FM broadcasters offer traffic messag-

grammes is activated, “TA” will light up in

es for their service area at regular intervals.

the display.

All traffic programme stations transmit a

To switch the priority on or off:

special carrier signal alongside their pro-

• Press the TA button.

grammes, which is decoded by your car ra-

dio. If this signal is identified, “TP” will ap-

When pressing TA while a message is be-

pear in the display (Traffic Programme).

ing broadcast, this message will be inter-

In addition to these, there are also stations

rupted. The unit will then switch back to the

which do not actually transmit traffic pro-

previous condition. The priority for all other

grammes themselves, but by using RDS-

traffic messages remains active.

EON they offer the possibility to receive the

Please note that several buttons have no

traffic messages broadcast by another traf-

function while a traffic announcement is

fic programme station in the same radio

broadcast.

network.

 

If you wish to have the priority for traffic an-

Beep tone

nouncements activated while listening to

If you leave the reception area of the traffic

one of these stations (e.g. NDR3), “TA” must

appear on the display panel.

programme station currently tuned into, you

If a traffic announcement is broadcast, the

will hear a beep tone approximately every

radio will automatically switch to the linked

30 seconds.

traffic programme station (in this case,

This tone will also be released when press-

NDR2) for the duration of the message and

ing a preset button which has no traffic pro-

return to the original programme (NDR3)

gramme allocated to it.

afterwards.

 

Switching off the beep tone

a)Tune into another station offering traf- fic information:

Press the rocker switch or

press a preset button which has a traffic programme station allocated to it.

Alternatively:

b)Switch off the priority for traffic an- nouncements:

Press TA.

“TA” will disappear from the display.

Automatic seek tuning start

(tape operation)

When leaving the reception area of the tuned in traffic programme station while listening to a tape, the system will automatically start searching for a new TA programme.

If no such station is found within approxi- mately 30 seconds, you will hear a warning beep every 30 seconds. To switch off the beep tone proceed as described above.

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

39

Image 18
Contents Bergamo RCR Montana RCR Wiesbaden RCR 13 12 Contents Quick reference DSC Mode a Remote control DisplayExtra rocker switch functions AUD BInsert KeyCard To switch over3, 4, 5, 6 preset buttons Flashing KeyCard tongueExtra function of lo button Preset ScanSRC Source Extra functionAUD Adjusts the treble and bass frequen- ciesSetting the balance left/right and the fader front/rear Extra function AUDRemote control Precautions Installation AccessoriesTraffic safety Important notesKeyCard theft protection system Short Additional Memory S.A.M Turn On Message T.O.MREG regional programme Radio operation with RDS Radio Data SystemSelecting a waveband AF Alternative frequencyManual tuning with Station tuningAutomatic tuning Storing stationsRecalling stored stations Scanning stored stations with Preset ScanSelecting the seek tuning sensi Scanning stations with RadioProgramme type Switching from stereo to monoLoudness NewsFolk Music Documentary PTY priority Traffic announcement priority Automatic seek tuning startReceiving traffic programme stations with RDS-EON On/offInserting a tape Tape operationFast Forward/Rewind Removing a tapeListening to the radio during fast tape winding with RM Care notesDSC programming AM on / OFF Bergamo RCRTo quit the DSC programming mode and store the adjustment Overview of DSC factory set- tingsVOL FIX Tuner SpecificationsAppendix Tape playerBlaupunkt-Werke GmbH