Recharging the battery | Installing the Lucca into a car |
Charging the battery
The rechargeable battery enables the Lucca to be operated without requiring an external source of power. The battery must be fully charged (by recharging it for approx. 5 to 6 hours) to achieve the maximum battery run time of up to 3 hours.
The battery charge indicator is always displayed in the top centre of the screen no matter whether you are navigating or using the Music Player or Picture Viewer. The battery charge indicator will display the following symbols:
•
: Lucca is connected to an external power source.
•
: Lucca is running on its internal battery. The battery has sufficient charge.
•
: Lucca is running on its internal battery. The battery is running low.
The number of dark blocks shown inside the battery indicates the charge left (0 to 3 blocks).
NB:
Lucca will issue a warning if the battery is running very low.
➜The battery can be recharged using either the supplied charger cable for the cigarette lighter or the optionally available charger.
NB:
•Only use
•Never dispose of defective battery
chargers as domestic waste! “designated” collection points.
Installing the Lucca into a car
The Lucca is equipped with a suction cup holder, which is designed for fastening to a windscreen, to enable it to be temporarily installed into a vehicle.
Caution:
Make sure that the Lucca is not installed in such a way as to obstruct your view or distract from the surrounding traffic.
Do not install the Lucca within range of the airbags.
Always make sure that the Lucca does not represent a hazard to vehicle passengers once installed in the event of emergency braking.
Attaching the suction cup holder
The supplied suction cup holder enables you to install the Lucca easily and safely into your vehicle.
➜Choose a place suitable for installing the Lucca on your windscreen.
➜The windscreen must be free from dust and grease to ensure optimum adhesion. If required, clean the windscreen before installation using a special windscreen cleaning cloth.
➜Press the adhesive plate of the suction cup against the windscreen.
➜Fold the arm on the adhesive plate towards the windscreen.
➜Adjust the suction cup holder. When doing so, make sure that the bar for attaching the Lucca is horizontal.
Removing the suction cup holder
The suction cup holder can be removed easily if you are changing vehicles.
➜Move the arm on the adhesive plate away from the windscreen.
➜Remove the adhesive plate carefully from the windscreen at its edge so as to allow air to enter into the space between the adhesive area and windscreen.
➜Carefully pull the suction cup off the windscreen.
7