ENGLISH
To select the scroll mode — SCROLL MODE
You can select the scroll mode for the disc information if it consists of more than 12 characters. When shipped from the factory, Auto Scroll mode is set to “SCROLL ONCE.”
•SCROLL ONCE: Scrolls only once.
•SCROLL AUTO: Repeats the scroll
(in
• SCROLL OFF: Cancels Auto Scroll.
Note:
Even if the scroll mode is set to “SCROLL OFF,” you can scroll the display by pressing DISP for more than 1 second.
To select the subwoofer cutoff frequency
—WOOFER FREQ
When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for your subwoofer. When shipped from the factory, the subwoofer cutoff frequency is set to “FREQ MID.”
• FREQ LOW: | Frequencies higher than |
| 50 Hz are cut off to the |
| subwoofer. |
• FREQ MID: | Frequencies higher than |
| 80 Hz are cut off to the |
| subwoofer. |
• FREQ HIGH: | Frequencies higher than |
| 120 Hz are cut off to the |
| subwoofer. |
To change the AM/FM channel intervals
—AREA CHANGE
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and 200 kHz for FM (AREA US settings).
You will have to change the channel intervals when using this unit in an area other than North America and South America.
• AREA EU: | Select this when using this |
| unit in an area other than |
| North and South America. |
| (9 kHz for AM and 50 kHz (for |
| manual tuning) / 100 kHz (for |
| searching) for FM) |
• AREA US: | Select this when using this |
| unit in North or South |
| America. (10 kHz for AM and |
| 200 kHz for FM) |
Note:
If the channel intervals settings are changed, the following will occur.
•The names assigned to the stations will be erased from memory. To reassign the names, see “Assigning names to the sources” on pages
23 – 24.
To adjust the line input level — LINE ADJ
Adjust the line input level properly when an external component is connected to the LINE IN plugs. When shipped from the factory, the line input level is set at level “00.”
If the input level of the connected component is not high enough, increase the input level properly. Without adjusting the line input level, you may be surprised at a loud sound when you change from the external component to another source.
20