Kenwood TM-V7A instruction manual Selecting Frequencies, Tuning Control, Microphone UP/DWN Buttons

SELECTING FREQUENCIES

■Tuning Control

Using the Tuning control is convenient when you are within easy reach of the transceiver front panel, and the frequencies to be selected lie near the current frequency.

1 Press [VFO] to select VFO mode.

CALL PWR

VOLSQL

2Turn the Tuning control to select a receive frequency.

CALL PWR

VOLSQL

•Clockwise rotation increases the frequency one frequency step at a time.

•Counterclockwise rotation decreases the frequency one step at a time.

•To change frequencies in steps of 1 MHz, press [MHz] first. Pressing [MHz] again cancels the 1 MHz function. To change in steps of 10 MHz, press

[F] + [MHz] first. Pressing [F] cancels the 10 MHz function; pressing [MHz] starts the 1 MHz function.

•If you cannot select a particular receive frequency, the

frequency step size needs to be changed. See	1
"CHANGING FREQUENCY STEP SIZE" {page 65} for
further information.	2
• You can also select frequencies via the microphone	3
keypad (MC-53DM only). See "KEYPAD DIRECT
ENTRY" {page 74}.	4
■ Microphone [UP]/[DWN] Buttons	5
	6
Using Mic [UP]/[DWN] for frequency selection is useful
	7
when mobiling or any time you are not immediately in
front of the transceiver.	8
Press [UP] or [DWN] once to change the receive	9
frequency by one frequency step in the direction
indicated by the button.	10
• Pressing and holding either button causes the frequency	11
to step repeatedly in one direction until the button is
released.	12
• To change frequencies in steps of 1 MHz (or 10 MHz),	13
press [MHz] (or [F] + [MHz]) first.
	14
	15
	16
	17
	18
	19
MC-53DM	20
	21

17