Kenwood TM-V7A Recalling the Call Channel, Changing Call Channel Contents Simplex

CALL CHANNEL

The Call channel can be used to store any frequency and related data that you will recall often. The Call channel can be programmed with a simplex or split frequency as well as related data that can be stored in the memory channels. No matter what mode the transceiver is in, the Call channel can always be selected quickly. You may want to dedicate the Call channel as an emergency channel within your group. In this case, the Call/VFO scan {page 48} will be useful.

The default frequency stored in the Call channel is shown below:

Version	VHF	UHF
U.S.A/ Canada	144 MHz	440 MHz
Europe/ General	144 MHz	430 MHz

The contents of the Call channel cannot be deleted; however, you can overwrite old data with new data as described in the next section.

■Recalling the Call Channel

1 Select the desired band.	1
2 Press [CALL] to recall the Call channel.	2
• "CALL" appears.	3
	4
	5
	6
	7
• To restore the previous mode, press [CALL] again.	8
• The Tuning control and microphone [UP]/[DWN] do	9
not function while the Call channel is selected.
■ Changing Call Channel Contents (Simplex)	10
	11
1 Select the desired band.
	12
2 Select the desired frequency and related data
	13
(Tone, CTCSS, DTSS, etc.) using VFO mode or
Memory Recall {page 31}.	14
3 Press [F], [CALL].	15
• The selected frequency and related data are stored in
	16
the Call channel. The transmit frequency from a split
memory channel is not stored.	17
• The previous mode is restored.
	18
Note: Lockout status is not copied from a memory channel to the
	19
Call channel.
	20
	21

33