Kenwood TM-V7A instruction manual User Setting, Monitor, Enter, Voice

To assign a function unavailable using the front panel keys:

1Press [MNU] to enter Menu mode.

2Select Menu No. 16 (Microphone).

CALL PWR

VOLSQL

3Press [s], then select Item No. 2 (PF 1) to No. 5 (PF 4).

CALL PWR

User Setting:
Selects the front panel key function you assigned	1
{page 72}.	2
Monitor:
	3
Makes the squelch open and allows you to monitor activity
on the current frequency. This function is useful when	4
adjusting the volume or when receiving weak signals.
• Pressing the re-programmed Mic key toggles Monitor ON or	5
OFF.	6
• Scan will not function if Monitor is ON (squelch open).
	7
Enter:
	8
Allows you to enter digits from the MC-53DM microphone.
Refer to "KEYPAD DIRECT ENTRY" {page 74}.	9
Voice:
	10

2 1

VOLSQL

Activates or deactivates the function that announces the
current Control band frequency using beeps of different	11
frequencies. Press any key to stop beeps.

4Press [SET] to select the desired function.

•Each time you press [SET], the selection changes as shown below:

User Setting ➞ Monitor ➞ Enter ➞ Voice ➞ PWR switch (PF 1 only) ➞ 1750 Hz Tone (TM-V7E only)

5Press [MNU] again to exit Menu mode.

PWR switch:	12
	13
Turns the transceiver ON or OFF. This function can be
assigned only to PF 1.	14
1750 Hz Tone (TM-V7E only):	15
Activates the Tone function and transmits a 1750 Hz tone
while you are holding down the re-programmed Mic key.	16
You need not press Mic [PTT].	17
• You can also use Transmit Hold to continuously send a
1750 Hz tone for 2 seconds after releasing the	18
re-programmed Mic key. To activate this function, access item	19
No. 3 (1750 Hz Timer) in Menu No. 5 (Repeater).
	20
	21

73