Kenwood TM-V7A instruction manual Naming Memory Channels

1

NAMING MEMORY CHANNELS

You can name memory channels using up to 7

5Press [SET].

• The first digit blinks.

2 alphanumeric characters. When you recall a named memory channel, its name appears on the display with the

3stored frequency. Names can be callsigns, repeater

4 names, cities, names of people, etc.

5Note:

◆You cannot use this function after having selected 140:140 memory

6 channel ratio.

CALL PWR

VOLSQL

7

8

◆You cannot name the Call, L1 to L3, nor U1 to U3 channels.

1 Recall the desired memory channel.

2 Press [MNU] to enter Menu mode.

6 Turn the Tuning control, or press Mic [UP]/[DWN], to

select the first digit.

• To skip by four characters when operating the above

control or keys, press [MHz]. Press [MHz] again to quit

9 3 Select Menu No. 4 (Memory).

10

CALL	PWR
11
12
VOL	SQL
13

14 4 Press [s], then select item No. 3 (Memory Name).

15
16	CALL	PWR
17
	VOL	SQL
18	2
	1
19
20
21

	this jump function.
7	Press [s].
	• The second digit blinks.
8	Repeat steps 6 and 7 to enter up to 7 digits.
	• After entering the 7th digit, pressing [s] causes an error
	beep to sound.
	• To re-enter the preceding digit, press [t].
	• To clear all digits and move back to the first digit, press
	[VFO].
9	Press [SET] again to complete the setting.
10	Press [MNU] to exit Menu mode.

Note:

◆Names can be assigned only to memory channels in which you have stored frequencies and related data.

◆The stored names can be overwritten by repeating steps 1 to 10.

◆The stored names also are erased by clearing memory channels.

32