Amplifier Section, Balance Control, Fader control

Amplifier Section

period, “000”. Following this, it is essential that you enter the correct code number.

Switching Code System Off

If you wish to switch the anti-theft code sy- stem off:

●turn off the radio,

●simultaneously press, and hold, preset buttons 1 and 4 ;

●turn the set back on. “Cod” will then appear in the display :.

●release the preset buttons 1 and 4 ;. “000” then appears in the display:.

●Enter the code number that is in the Blaupunkt car radio pass and confirm: See example “First-time operation ...”.

The anti-theft coding system has now been deactivated.

The anti-theft code system is now activated. Now whenever the set is turned on, “CODE” will appear briefly in the display :.

Optical indication of theft protection

As optical warning of the encoded car radio, the LED 6 flashes when the ignition is switched off, provided the car radio has been connected correspondingly.

For this, please see the corresponding instal- lation instructions.

ON/OFF

For switching the set on,

●turn button 1 .

Your stereo is now ready for operation.

For switching the set off,

●turn button 1 .

Volume control

●turn button 1.

Balance Control

Use button 1to balance the sound impres- sion of the right and left channel speaker.

●Pull (lock in) button and turn.

After the adjustment

●slightly press button.

DEUTSCH

ENGLISH

NEDERLAND ITALIANO FRANÇAIS

Switching the Code System Back On If you wish to re-activate the anti-theft code system:

●turn the radio off,

●simultaneously press, and keep de- pressed, preset buttons 1 and 4 ;,

●turn the set back on. “Cod” briefly ap- pears in the display : and then the set is switched on.

Fader control

If four loudspeaker are connected, the front/ rear sound impression of the loudspeakers (fader) can also be modified using lever B.

Adjusting trebles

●turn button @.

Adjusting basses

●turn button A.

PORTUGUES ESPAGÑOL SVENSKA