Adjusting the DVD Level
The volume (signal level) for Dolby Digital, Dolby PL II, DTS and PCM modes can be set.
•Avoid stopping, pausing, switching the disc, cueing,
Setting item: DVD Level
Adjust the level by touching [
] or [
] of the desired adjusting mode.
The level can be adjusted in the range of
Linear PCM Setting
The output when playing discs recorded in linear PCM can be set to 2 or 3 channels.
Setting item: PCM Mode
Touch [
] or [
] of PCM Mode to select 2CH or 3CH.
2CH: 2ch output (L/R)
3CH: 3ch output (L/R/CENTER)
•This adjustment is ineffective when the speaker is set Center to OFF in “Setting the Speakers” (page 29).
Storing Settings in the Memory
Adjustment or setting contents can be stored.
Contents that can be stored vary depends on the audio processor used.
1 Touch [ 
] of PRESET on the A.Processor list screen.
The preset station setting list is displayed.
2 Touch [MEMORY] of any preset stations (1 through 6).
The setting contents are stored.
•The stored contents will not be deleted even when the battery power cord is detached.
Calling up the Preset Memory
1 Touch [ 
] of PRESET on the A.Processor list screen.
The preset station setting list is displayed.
2 Touch [ 
] of any preset stations (1 through 6) to select the preset memory.
•It takes a few moments to call up the preset memory.
IMPRINT Operation (Optional)
Alpine introduces IMPRINT - the world’s first technology that thoroughly eliminates
When the IMPRINT audio processor
To display the IMPRINT mode screen:
To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.
1Bring your vehicle to a complete stop at a safe location. Engage the parking brake.
2Keep pushing the foot brake and release the parking brake once then engage it again.
3When the parking brake is engaged for the second time, release the foot brake.
•For automatic transmission vehicles, place the transmission lever in the Park position.
Now, the locking system for the IMPRINT mode operation has been released. Engaging the parking brake can reactivate the IMPRINT mode, as long as the car’s ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3) of “To display the IMPRINT mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To display the IMPRINT mode screen.”
Changing MultEQ mode
MultEQ, developed by Audyssey Labs, automatically corrects the audio for the listening environment. The system is optimized for selected positions in the vehicle. To accomplish this, MultEQ must take measurements of the vehicles response characteristics. For details on the set up procedure, consult your authorized Alpine dealer.
1 Press and hold SETUP of the unit for at least 2 seconds.
The SETUP selection screen is displayed.
2 Touch [ 
] of Imprint setup.
The Multi EQ mode selection screen appears.
3 Touch [
] or [
] of Multi EQ to change the setting.
Setting contents: OFF / CURVE 1/CURVE 2
OFF: Adjust the audio settings manually to create your own preference.
CURVE1/
CURVE2: Corrects the audio for the listening environment automatically.
•The Curve mode can be selected only when CURVE 1 and CURVE 2 are stored.
•When Multi EQ is set to CURVE 1 or CURVE 2, Media Xpander,