Alpine iXA-W407 Auxiliary Device Optional, Operating Auxiliary Devices Optional, 45-EN

Auxiliary Device (Optional)

Operating Auxiliary Devices (Optional)

To operate your devices connected to the AUX terminals on the rear panel of this unit (AUX mode), follow the procedure described below.

WARNING

It is dangerous (and illegal in many states) for the driver to watch the TV/Video while driving the vehicle. The driver may be distracted from looking ahead and an accident could occur.

Install the iXA-W407 correctly so that the driver cannot watch TV/Video unless the vehicle is stopped and the emergency brake is applied.

If the iXA-W407 is not installed correctly, the driver will be able to watch the TV/Video while driving the vehicle and may be distracted from looking ahead and cause an accident. The driver or other people could be severely injured.

To activate your auxiliary devices:

To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1Bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2Keep pushing the foot brake and release the parking brake once then engage it again.

3When the parking brake is engaged for the second time, release the foot brake.

•For automatic transmission vehicles, place the transmission lever in the Park position.

Now, the locking system for the AUX mode operation has been released. Engaging the parking brake can reactivate the AUX mode, as long as the car’s ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of “To activate your auxiliary devices.”

Each time the ignition is turned OFF, perform the procedure of “To activate your auxiliary devices.”

•If you try to activate the auxiliary device while driving, the display will show the warning-PICTURE OFF FOR YOUR SAFETY.

1 Press SOURCE to activate mode switching screen.

2 Slide the display horizontally with your fignger to select Audio/Visual mode.

Each time you slide the display, the mode switches circularly in the following order :

Audio/Visual Navigation Camera Telephone Multi Info Audio/Visual

3 Slide the display vertically with your finger, or press SOURCE repeatedly to select AUX* source.

*The name which is given as the source name in “Setting the AUX Mode” on page 20 is displayed.

4 Touch the AUX source window displayed in the center of the screen.

The AUX source is activated and the display changes to the external input screen.

•If the AUX source is not displayed on the main menu, set AUX IN to ON by following “Setting the AUX Mode” (page 20).

•The display mode changes by touching [WIDE].

For operation, refer to “Switching Display Modes” on page 14.

•After connecting the KCA-410C, its AUX input can be used only in INTERRUPT MODE. For details, refer to the KCA-410C Owner’s Manual.

45-EN