Alpine CDA-9887 Installation, ~+R, Pull the unit out, keeping it unlocked as you do so

Page 41

Installation

Caution

Do not block the unit's fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.

Air ventilation hole

~~Detachable Front

V Panel

Caution

When you install this unit in your car, do not remove the detachable front panel.

If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.

•The main unit must be mounted within 35 degrees of the horizontal plane, back to front.

~,/:/~,;

Less than 35°-:,""", ,

a "'",J,:

Mounting Sleeve

1 (Included)

Dashboard

~

Pressure Plates*

*If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem.

Remove the Detachable Front Panel (refer to

page 6). Remove the mounting sleeve from the main unit (see "Removal" on page 39).

2

Hex Nut (M5)

Screw

Metal

Mounting

Strap

Ground Lead

Chassis

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle'schassis.

•For the screw marked" *2 ", use an appropriate screw for the chosen mounting location.

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the CDA-9887. Connect all other leads of the CDA-9887 according to details described in the CONNECTIONS section.

3

Slide the CDA-9887 into the dashboard until it clicks. This ensures that the unit is properly locked and will not accidentally come out from the dashboard.

Install the detachable front panel.

Removal

1.Remove the detachable front panel.

2.Insert the bracket keys into the unit, along the guides on either side. The unit can now be removed from the mounting sleeve.

This unit

~~ Bracket keys

.. ~ (Included)

~

3. Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

~~

~+R

		Front Frame
	This unit	Screws (M5 x 8)
	This unit	(Included)
		(Included)

•Secure the ground lead of the unit to a clean metal spot using a screw (*3) already attached to the vehicle's chassis.

39-EN

Image 41

Contents CDA-9887 Intended Contents Operating Instructions Installation and Connections Operating Instructions ~ ~ Illo§@ Press SOURCE/! to turn on the unit Accessory ListTurning Power On and Off Lowering Volume Quickly Adjusting VolumeSetting the Time and Calendar Initial System Start-UpTuning to Preset Stations Presetting Stations AutomaticallyPress TUNE/A.ME to select the tuning mode Listening to RadioPlayback Frequency Search FunctionPress .z Open Insert a disc with the label side facing upX. Random Play Repeat PlayQuick Search Searching from CD TextAbout MP3/WMA/AAC Press ~/ESe during playID3 tagsIWMA tags Supported playback sampling rates and bit ratesProducing MP3IWMAJAAC discs Media supportedPress MultEQ to select ON/OFF mode Equalizer PresetsEach press changes the mode as follows Turning MultEQ on/offAdjusting and Storing the Graphic Equalizer Curve Setting EQ modeAdjusting and Storing the Parametric Equalizer Curve Recalling the ,Stored Equalizer Curve About the CrossoverAdjusting and Storing the Crossover Settings = distance to farthest speaker distance to other speakers About Time CorrectionAdjusting and Storing the Time Correction Setting the Time Correction UnitSetting the MX Mode Recalling the Stored Time Correction SettingsPress Title Displaying the TextDisplay will change every time the button is pressed About the indication displayDisplaying Time Blackout Mode On and OffPress Title repeatedly until the time is displayed About TextBirthday Opening Message Setting Birthday Set Setting the Bluetooth in ConnectionSetting the Clock Display Clock Mode 22-EN23-EN 24-EN Receiving Channels with the SAT Radio Receiver Optional 25-EN26-EN Storing Channel PresetsChecking the SAT Radio ID Number Receiving Stored ChannelsPress FUNC./SETUP to cancel the function mode Canceling the stored Alert Memory Sirius only27-EN Search FunctionQuick Search Function 28-ENReceiving Weather or Traffic Information from SAT Radio Instant Replay Function Sirius onlyPlayback 29-ENSearching for a desired Song 30-ENDirect Search Function For example Searching by Artist nameRepeat Play 31-ENRandom Play Shuffle M.I.X Displaying the TextControlling CD Changer Optional 32-ENPlaying MP3 Files with the CD Changer Optional Multi-Changer Selection Optional~ UP Button Controls on Remote ControlOperating the Audio Processor Opening the battery cover Battery ReplacementReplacing the battery Closing the coverCase of Difficulty 35-EN36-EN High TemperatureOFF AIR Specifications38-EN Installation and ConnectionsPull the unit out, keeping it unlocked as you do so Installation~+R EQ/DIVL~ 40-ENSwitched Power Lead Ignition Red CD Antenna Receptacle Power Antenna Lead BlueBattery Lead Yellow Remote Turn-On Lead BluelWhiteTo prevent external noise from entering the audio system 42-ENALPINE-1 FfffMLPINELimited Warranty Repita los pasos 3 y 4 para ajustar otro altavoz Repeat steps 3 and 4 to set another speakerRepetez les etapes 3 et 4 pour regler une autre enceinte Upprepa steg 3 till 4 om du viti stilla in fler h6gtalare Per configurare un altro altoparlante, ripetere i punti 3 e~Rotary encoder flAtiiell 0.0 ~ 336.6 em 14E$t Rotary encoder iJ!JiSJeil 0.0 ~ 336.6 emCassette Player Monitor Controller CD Player Video Monitor Factory installed Alpine OtherMD Player Navigation DVD Player Mobile Mayday CD Changer Video Tape PlayerBusiness Reply Mail PERrtIT no International Business Reply MAIL/REPONSE Payee