Sony KV-32FS100 Power-Cord Protection, Antennas Outdoor Antenna Grounding, Lightning, Servicing

Page 5

Never block the slots and openings by placing the set on a bed, sofa, rug or other similar surface.

Never place the set in a confined space, such as a bookcase or built-in cabinet, unless proper ventilation is provided.

Do not place the set near or over a radiator or heat register, or where it is exposed to direct sunlight.

Power-Cord Protection

Do not allow anything to rest on or roll over the power cord, and do not place the set where the power cord is subject to wear or abuse.

Grounding or Polarization

This set may be equipped with a polarized

alternating current line plug (a plug having one blade wider than other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug still fails to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

Antennas

Outdoor Antenna Grounding

If an outdoor antenna is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits.

WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL.

Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code (NEC) in USA and Section 54 of the Canadian Electrical Code in Canada provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Antenna Grounding According to the NEC

Antenna Grounding According to the National Electrical Code, ANSI/NFPA 70.

 

ANTENNA

 

LEAD IN

 

WIRE

GROUND

 

CLAMP

 

 

ANTENNA

 

DISCHARGE UNIT

 

(NEC SECTION 810-20)

ELECTRIC

 

SERVICE

GROUNDING CONDUCTORS

EQUIPMENT

(NEC SECTION 810-21)

 

GROUND CLAMPS

 

POWER SERVICE GROUNDING

NEC - NATIONAL ELECTRIC CODE

ELECTRODE SYSTEM

(NEC ARTICLE 250, PART H)

Lightning

For added protection for this television receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna.

This will prevent damage to the receiver due to lightning and power-line surges.

Service

Damage Requiring Service

Unplug the set from the wall outlet and refer servicing to qualified service personnel under the following conditions:

When the power cord or plug is damaged or frayed.

If liquid has been spilled into the set or objects have fallen into the product.

If the set has been exposed to rain or water.

If the set has been subject to excessive shock by being dropped, or the cabinet has been damaged.

If the set does not operate normally

when following the operating instructions. Adjust only those controls that are specified in the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the set to normal operation.

When the set exhibits a distinct change in performance — this indicates a need for service.

Servicing

Do not attempt to service the set yourself since opening the cabinet may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

Replacement Parts

When replacement parts are required, be sure the service technician certifies in writing that he has used replacement parts specified by the manufacturer that have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock, or other hazards.

Safety Check

Upon completion of any service or repairs to the set, ask the service technician to perform routine safety checks (as specified by the manufacturer) to determine that the set is in safe operating condition, and to so certify. When the set reaches the end of its useful life, improper disposal could result in a picture tube implosion. Ask a qualified service technician to dispose of the set.

Image 5
Contents Operating Instructions Page Trademarks and Copyrights Protecting the TVOwner’s Record Cleaning Use Power SourcesInstallation AccessoriesService Damage Requiring Service Power-Cord ProtectionReplacement Parts Safety CheckPage Contents Page Introduction Introducing the FD Trinitron Wega FeaturesAbout this Manual Batteries for the Remote ControlFront Panel Menu Controls Operating InstructionsIntroduction Using the Remote ControlTV/VIDEO TV Rear Panel Picture quality when you need to switch between scrambledJack Description Unscrambled cable channelsJacks provide better picture quality than the VHF/UHF jack Connecting Your TV JackDescriptionConnects to the Audio LMONO, R input jacks on your audio SystemNot supplied Basic ConnectionsTV with Indoor or Outdoor Antenna, or Catv Cable Page Page Connecting a TV and VCR Connecting Additional EquipmentConnecting Your TV Optional connectionCable Box Connecting a TV, VCR, and Cable BoxRear of TV Splitter Rear of TV Connecting a TV and Satellite ReceiverConnecting Your TV Optional connection Connecting a TV, Satellite Receiver, and VCR Rear of TV Rear of DVD Player Connecting a DVD PlayerConnecting an Audio System Connecting a CamcorderPage To perform Auto Program again Setting Up the TV AutomaticallyTo reset the TV to factory settings Customize your channel settings Make adjustments to your picture settingsQuick Start to the Menus Menu Allows you toUsing Basic Functions Menu Allows you to Displaying Picture in Picture Using Picture in Picture PIPTo use PIP To check your PIPPIP Functions buttons Using Basic FunctionsYellow labeled Description PIP button To change channels/programs in the PIP windowSetups that affect your ability to use PIP How to access menus Using the MenusUsing the Video Menu Using the Audio Menu Operating Instructions Audio Out Cable Using the Channel Setup MenuFavorite Channels Channel Operating Instructions Auto ProgramSkip/Add LabelTo use the Parent Menu Using the Parent MenuTo access the Parent menu, refer to the following steps Changing your Password Setting the RatingParental Control Select a CountryPress , then use the 0 9 buttons to enter your password Using the Custom MenuInformation for Parents To view a program that exceeds the TV ratingTV Rating United States Selecting Custom Rating OptionsMovie Rating Block UnratedAllow English Rating Canada Selecting Custom Rating OptionsFrench Rating A. RatingTo access the Timer menu, refer to the following steps Using the Timer MenuTimer 1 TimerUsing the Setup Menu To access the Basic menu, refer to the following steps Using the Basic MenuPress G to decrease picture contrast Use the g to increase picture contrastPage VCR codes Programming the Remote ControlCable box codes Operating Instructions VCR codesSatellite receiver codes Laser Disc Player codesOperating a VCR Press To Other InformationOperating a DVD Press To Operating a Laser Disc Press ToTroubleshooting Remote control Problem Possible Solutions Cable stationsCannot access Using the BasicTV and timer LED flashes After disconnectingParental Control You lost yourFor all models except as noted SpecificationsKV-36FS100, KV36FS200 Index Page Page Page Page Page Page Page Page Sony Corporation
Related manuals
Manual 64 pages 12.57 Kb Manual 64 pages 12.58 Kb