Sony MZ-N510 operating instructions While using group function, Analog connection

Symptom	Cause/Remedy
Track marks	• This is due to the MiniDisc system limitations. When the data of a
cannot be erased.	track is fragmented, the track mark of a fragment under 12 seconds
	long (recorded in SP stereo), 24 seconds long (recorded in LP2
	stereo mode or monaural mode), or 48 seconds long (recorded in
	LP4 stereo mode) cannot be erased. You cannot combine tracks
	recorded in different recording modes, e.g., a track recorded in
	stereo and a track recorded in monaural; nor can you combine a
	track recorded with digital connection and a track recorded with
	analog connection.
The disc cannot be	• The component does not support LP2 stereo or LP4 stereo.
edited on another	, Edit on other component that support LP2 stereo or LP4 stereo.
component.
“TrFULL” appears	• This is due to the MiniDisc system limitation. Repeated recording
even before the	and erasing may cause fragmentation and scattering of data.
disc has reached	Although those scattered data can be read, each fragment is
the maximum	counted as a track. In this case, the number of tracks may reach 254
track number or	and further recording is not possible. To continue recording, erase
recording time.	unnecessary tracks.

While using group function

Symptom	Cause/Remedy
The group	• While using a disc with no group setting, an attempt was made to
function does not	select some group-related menu.
operate.	, Use a disc with group setting.
A track cannot be	• This is due to the MiniDisc system limitations. Group information
recorded to a new	has been written to the area where the disc name is stored. The disc
group. A new	name and track names are recorded in the same area, which can
group cannot be	store a maximum of approximately 1,700 characters. If the total
created.	number exceeds this amount, a new group cannot be created even
	though group mode is on. It is also impossible to make group
	settings at this time.

61