Programming
2Select your desired categories by pressing 1 to 9.
R “
” is displayed next to the selected category numbers.
R To cancel a selected category, press the same dial key again. “
” disappears.
3MOKN a M
N
Incoming call barring
This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls.
When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit emits no sound to the caller, and disconnects the call. (Caller ID subscribers only)
Important:
RWhen the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list
(page 35) with 
after the call is disconnected.
Storing unwanted callers
You can store up to 100 phone numbers in the call barred list.
Important:
RYou must store the phone number with an area code in the call barred list.
nFrom the caller list:
1 M
N
2 MbN: Select the entry to be barred. a MDetailN a MMenuN
3 MbN: “Save CID” a MOKN
4 MbN: “Caller Barred” a MOKN
5 MbN: “Yes” a MOKN a M
N
nBy entering phone numbers:
1 MMenuN (right soft key) #217 a MAddN
2Enter the phone number (24 digits max.). a MOKN
3M
N
Viewing/editing/erasing bar call numbers
1MMenuN (right soft key) #217
2MbN: Select the desired entry.
R To exit, press M
N.
3To edit a number:
MEditN a Edit the phone number. a
MOKN a M
N
To erase a number:
MEraseN a MbN: “Yes” a MOKN a
M
N
Baby monitor
This feature allows you to listen in on a room where another handset is located, allowing you to easily monitor from different areas of the house or place. The monitored handset (placed in a baby’s room, for example) will automatically call the monitoring handset or the phone number stored when it detects sound.
Important:
RYou should perform a test run of the baby monitor procedure to ensure that the baby monitor feature is set correctly. For example, test its sensitivity. Check the connection if you are diverting the baby monitor to an outside line.
Note:
RBoth the monitored and monitoring handsets must select the same base unit in order to use the baby monitor feature (page 33).
RIf the unit is connected to a PBX system, you cannot set the baby monitor.
RDuring the monitoring mode, battery consumption is faster than usual. We recommend leaving the monitored handset on the base unit or charger.
RThe monitored handset never rings during the monitoring mode.
29
PRW110FX(en)_0724_ver012.pdf 29
2013/07/24 13:40:26