Configuring WAP parameters
Select the Advanced… menu, then the configuration menu. Choose from the
Logon parameters is used to select or modify your access provider's logon parameters or configure the parameters of other access providers.
The active access service is preceded with a start.
Configuration of GSM and GPRS parameters (depending on model):
All information to be entered in the parameters are provided by your operator or access provider.
-Choose desired access service, then press Choice.
-Enter title of service and accept.
-Enter Internet address of home page and accept.
-Enter parameters of preferred logon:
•GPRS otherwise GSM (by default): the logon to WAP services uses the GPRS as a priority. However, in the event of unavailability of the GPRS network, the GSM network is used to establish the link.
•GPRS: the logon to WAP services uses the GPRS network exclusively.
•GSM: the logon to WAP services uses the GSM network exclusively.
The GSM parameters to be entered are:
-User name
-Password
-IP address of WAP gateway
-Port type (secure or insecure)
-Call number
-Access mode (digital, analogue or automatic)
In automatic mode access can be gained to the operator's network by a digital link and by an analogue link to a different network (in roaming).
The GPRS parameters to be entered are:
-User name
-Password
-IP address of WAP gateway
-Port type (secure or insecure)
- APN: if no APN has been defined, press the right programmable key | [Choice] then the APN menu. |
Select or add and APN. |
|
WAP | 33 |