Canon 3920 manual Select Base Unit Location

Page 13

User’s Guide	2 Installing the Telephone

Select Base Unit Location

•Select a location that is not subject to excessive heat or humidity.

•Determine if the base unit will sit on your desk or be wall mounted.

•Place the base unit near a standard 120VAC outlet and within reach of a telephone jack that is connected to the PARTNER ACS. Avoid a location that is surrounded by metal surfaces. Make sure this outlet cannot be turned off by a switch.

! WARNING:

If the base unit is installed in a separate building from the PARTNER ACS, you must install In-Range Out of Building (IROB) protectors. The IROB used with the Avaya 3920 Wireless Telephone is Module 146D (IROB Two) Dual IROB. To order an IROB, contact your local Authorized Dealer.

•Place the base unit away from any electrical component, such as PCs, monitors, other telephones, and the PARTNER ACS.

•If more than one unit is being installed, each base unit must be placed at least 15 feet apart.

•Keep the base unit and handset away from sources of electrical noise, such as motors and fluorescent lighting. For more information about installation (including the positioning of base units and the installation of repeaters), please refer to the Avaya 3920 Wireless Telephone Planning and Installation Guide.

! WARNING:

The Avaya 3920 Wireless Telephone handset, base unit, and repeaters are designed for indoor use and installation. These devices are not water proof and are not designed for use in wet or moist environments.

Select Base Unit Location 13

Image 13

Contents Avaya 3920 Wireless Telephone Federal Communications Commission Statement Trademarks Important Safety Instructions Contents Troubleshooting Specifications Accessories Welcome IntroductionConventions OrganizationRelated Documents Introduction Overview Installing the TelephoneBase Unit Select Base Unit Location Connect Telephone Cord Install the Base Unit on a DesktopCheck to see that the power LED is on Attach Wall Mount Stand to Base Unit Install the Base Unit on a Standard Wall PlateLine In jack Adapter Insert Mounting Screws Install the Base Unit Directly on a WallLine In jack Place Base Unit on Wall Screw Posts Plug Telephone Cord into Telephone Jack Apply Power to Charger Unit Apply Power to the Charger UnitInsert Mounting Screws into Wall Mount the Charger Unit on a Wall OptionalRemove Battery Cover Install the Handset BatteryClose Battery Cover Place Handset in Charger Unit Charge the Battery for the First TimeCharge Spare Battery Charge the Spare BatteryUser’s Guide Install Headset Install a Headset OptionalBelt clip is designed to fit snugly onto the handset Attach the Belt Clip to the HandsetPress firmly until it snaps into place Remove Belt Clip from the Handset Remove the Belt Clip from the HandsetInstalling the Telephone About Your Telephone Handset Avaya 3920 Wireless Telephone HandsetButton Description Vol Handset Display Base Unit Base UnitCharger Unit Charger UnitClean Charger Unit Contacts Clean the Charger Unit ContactsLow Battery Indications BatteryAbout Your Telephone Handset Modes Using Your TelephoneMake a Call Handling CallsAnswer a Call Answer an Intercom Call Make an Intercom CallPlace a Call on Hold Transfer a CallMute a Conversation Conference a CallChange Earpiece Volume Changing Handset SettingsChange Ring Type and Volume Turn Ringer Off Set Vibrate ModeSet Silent Alert Set the End of Range Alarm Using Your Telephone Troubleshooting Wireless Telephone Planning Wireless Telephone Planning and Installation Installation Guide to change the confirmation Specifications Specifications Repeater Accessories Accessories