Canon 3920 manual Wireless Telephone Planning

Page 54

A Troubleshooting	User’s Guide

SEARCHING...	You may be at the range limit. Move back
or	within the system range limit (for example,
OUT OF RANGE	move closer to the base unit or a repeater.)
appears in the	Consider installing a repeater if you
handset display.	experience this condition frequently.
	Make sure there is power going to the base
	unit.
	Check the connection between the PARTNER
	ACS and the base unit.
	Determine the number associated with the
	telephone. Dial that telephone number from a
	“wired” telephone. If you hear busy tone, the
	base unit is not communicating with the
	PARTNER ACS. Perform the following steps:
	• Check the power.
	• Verify that the telephone cord is connected
	to the base unit.
	• Make sure the handset is properly
	registered to the base. See the Avaya 3920
	Wireless Telephone Planning and
	Installation Guide to register the handset
	with the base unit.
	• Verify that the installation guidelines have
	been followed, especially for systems
	where there are more than three Avaya
	3920 Wireless Telephones.

ACQUIRING	Make sure the telephone cord is seated
LINK appears in	properly in the base unit and in the wall jack.
the handset
display.

54

Image 54

Contents Avaya 3920 Wireless Telephone Federal Communications Commission Statement Trademarks Important Safety Instructions Contents Troubleshooting Specifications Accessories Introduction WelcomeOrganization ConventionsRelated Documents Introduction Installing the Telephone OverviewBase Unit Select Base Unit Location Install the Base Unit on a Desktop Connect Telephone CordCheck to see that the power LED is on Install the Base Unit on a Standard Wall Plate Attach Wall Mount Stand to Base UnitLine In jack Adapter Install the Base Unit Directly on a Wall Insert Mounting ScrewsLine In jack Place Base Unit on Wall Screw Posts Plug Telephone Cord into Telephone Jack Apply Power to the Charger Unit Apply Power to Charger UnitMount the Charger Unit on a Wall Optional Insert Mounting Screws into WallInstall the Handset Battery Remove Battery CoverClose Battery Cover Charge the Battery for the First Time Place Handset in Charger UnitCharge the Spare Battery Charge Spare BatteryUser’s Guide Install a Headset Optional Install HeadsetAttach the Belt Clip to the Handset Belt clip is designed to fit snugly onto the handsetPress firmly until it snaps into place Remove the Belt Clip from the Handset Remove Belt Clip from the HandsetInstalling the Telephone About Your Telephone Avaya 3920 Wireless Telephone Handset HandsetButton Description Vol Handset Display Base Unit Base UnitCharger Unit Charger UnitClean the Charger Unit Contacts Clean Charger Unit ContactsBattery Low Battery IndicationsAbout Your Telephone Using Your Telephone Handset ModesHandling Calls Make a CallAnswer a Call Place a Call on Hold Make an Intercom CallAnswer an Intercom Call Transfer a CallConference a Call Mute a ConversationChanging Handset Settings Change Earpiece VolumeChange Ring Type and Volume Set Vibrate Mode Turn Ringer OffSet Silent Alert Set the End of Range Alarm Using Your Telephone Troubleshooting Wireless Telephone Planning Wireless Telephone Planning and Installation Installation Guide to change the confirmation Specifications Specifications Repeater Accessories Accessories