To open the OSD, press the Control Wheel once to display the OSD Selection Menu. Rotate the Control Wheel to highlight the icon representing the parameter you wish to adjust and press the Control Wheel to select that parameter. Rotate the Control Wheel to adjust the value. When you are satisfied, press the Control Wheel to return to the OSD Selection Menu.
You will see the follwing display in your iWear® AV920.
OSD | Effect | |
Icon | ||
| ||
| LCD Brightness |
Contrast
Video Mode Control 2D/3D
Backlight Brightness
Reset to factory defaults
Exit OSD
Monoscopic 2D and Stereo 3D Modes
When using stereoscopic 3D content it may be necessary to adjust the iWear® AV920 3D mode. When viewing 3D content in 2D mode it will look fuzzy on the display. If this happens, adjust viewing mode from 2D to 3D stereo mode by pressing the Contol Wheel on the Video Mode Contol 2D/3D icon in the OSD and then select one of the three options. Make sure you select the appropriate 3D mode so that each video display has the correct left and right eye information.
It is recommended to use 2D mode for all non 3D content. Although you can view 2D content in 3D mode the resolution is cut in half and there will be differences in the video to each eye.
Cleaning
Use a soft dry cloth to clean your iWear® AV920 and its optics. Do not use liquid cleaners.
Updating
To exit the OSD, select the OSD Exit icon or wait
Your iWear® AV920 is fully field upgradable to ensure that you have the best experience possible. To upgrade your iWear® AV920 firmware or to download updated software, please visit www.vuzix.com/support.
6