Weslo WLTL46080 user manual

Page 8

3.You have one of two types of Carriage Pins (38). If you have type 2 (refer to the drawing), make sure the Carriage Pin Knob (39) is attached to the Carriage Pin (38).

Slide the Weight Carriage (23) onto the Lat Tower (34). Make sure that the Weight Carriage is turned as shown in the inset drawing. Slide the Weight Carriage to the position shown and insert the Carriage Pin (38) through the Weight Carriage and the Lat Tower.

4.Hold the Lat Tower (34) in the position shown. Make sure that the Lat Tower is turned as shown on page 5.

Attach the Base Plate (27) and the Corner Base

(33)to the Lat Tower (34) with two 3/8” x 3 1/4”

Bolts (32), two 3/8” Washers (31), and two 3/8” Jam Nuts (11).

Lay the Lat Tower (34) down on the floor so that it cannot be tipped over. The assembly of the Lat Tower will be completed in step 17.

5.Identify the indicated end of the Lat Cable (40). Attach the Lat Cable to the tab on the Weight Carriage (23) with a 3/8” x 1” Lat Bolt (141), a 3/8” Washer (31), and a 3/8” Jam Nut (11). Note: Do not fully tighten the Jam Nut.

8

3
	Type 1
39	38
	38
Type 2		23
Type 2
		34
		Weight Tube
		must angle upward
4
		34
	27
		31
	11	33
		33
		32
		31
5
		40
	11	31
		141
		Tab
		23

Image 8

Contents Model No. WLTL46080 Serial No Customer HOT LineTable of Contents Important Precautions One decal on each side Before You Begin Part Identification Chart Assembly Page Turns freely Make sure that the Cable Trap 47 is turned toPosition shown, and that the Pulley Nut. The Leg Lever must pivot freely Fully tighten all four 1/4 x 3/4 Screws 3 used in steps 12Page Refer to . Tighten all parts assembled in step Performant Lubetm Walking Belt How to Operate the TreadmillHOW to Plug in the Power Cord HOW to Lower the Treadmill for USE HOW to Fold the Treadmill for StorageDiagram of the Console Insert the key fully into the power switchResetbelt. the speed control and start the walking Step by Step Console OperationPress the Mode button to select the desired Monitor mode When you are finished, stop the walking belt Remove the keyHOW to Change the Incline of the Treadmill Measure your pulse, if desiredWorkout Guidelines How to Exercise on the TreadmillExercise Intensity Suggested Stretches How to Operate the Weight BenchHOW to Lower the Bench for USE HOW to Adjust the Backrest Attaching Weights to the Weight CarriageLOCKING/UNLOCKING the Weight Carriage Attaching Weights to the LEG LeverHow to Exercise on the Weight Bench Strength Training GuidelinesExercise Form Staying MotivatedTop View Trouble-Shooting and MaintenanceProblem The power turns off during use Problem The weight carriage sticks when the lat bar is used Key Qty Description Part List-Model No. WLTL46080R0898E Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT How to Order Replacement PartsLimited Warranty 102 142 141 1314 144 Exploded