MAINTENANCE AND TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and | ||||
follow the steps listed. If further assistance is needed, please see the front cover of this manual. |
| |||
PROBLEM: The power does not turn on |
|
|
|
|
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | ||||
is plugged into a properly grounded outlet (see page 9). Use only a | ||||
that meets all of the specifications described on page 9. Important: The treadmill is not compatible | ||||
with |
|
|
|
|
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. | ||||
c. Check the reset/off circuit breaker located on the | c |
|
|
|
treadmill frame near the power cord. If the switch |
|
|
| |
protrudes as shown, the circuit breaker has tripped. |
|
|
|
|
To reset the circuit breaker, wait for five minutes, | Tripped |
| Reset |
|
and then press the switch back in. |
|
| ||
PROBLEM: The power turns off during use |
|
|
|
|
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait | ||||
for five minutes and then press the switch back in. |
|
|
|
|
b. Make sure that the power cord is plugged in. |
|
|
|
|
c. Remove the key from the console. Reinsert the key fully into the console. |
|
| ||
d. If the treadmill still will not run, please see the front cover of this manual. |
|
|
| |
PROBLEM: The displays of the console do not function properly |
|
|
|
|
SOLUTION: a. Remove the key from the console and UNPLUG THE | a |
|
|
|
POWER CORD. Remove the five indicated Hood | 23 |
|
| |
Screws (8) and two Foot Rail Screws (52). Then, re- | 852 | 8 | 8 | |
move the Hood (23). | 52 | |||
|
|
| 8 | |
|
|
|
| |
Locate the Reed Switch (46) and the Magnet (49) on the left side of the Pulley (53). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8". If necessary, loosen the indicated Screw (5), move the Reed Switch slightly, and then retighten the Screw. Reattach the Hood (not shown), and run the treadmill for a few minutes to check for a correct speed reading.
1/8"5 | 53 |
46 | 49 |
Top View |
|
13