Weslo WMTL19408 user manual

Page 4

22. Inspect and properly tighten all parts of the

scribed in this manual. Never remove the

treadmill regularly.

motor hood unless instructed to do so by an

23. Never drop or insert any object into any

authorized service representative. Servicing

other than the procedures in this manual

opening.

should be performed by an authorized service

24. DANGER: Always unplug the power

representative only.

25. This treadmill is intended for in-home use

cord immediately after use, before cleaning

the treadmill, and before performing the main-

only. Do not use this treadmill in any commer-

tenance and adjustment procedures de-

cial, rental, or institutional setting.

WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for persons over the age of 35 or persons with pre-existing health problems. Read all instructions before using. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product.

SAVE THESE INSTRUCTIONS

The decals shown here have been placed on the tread- mill. If a decal is missing, or if it is not legible, please go to www.iconservice.com and order a free replace- ment decal. Apply the decal in the location shown. Note: The decals are not shown at actual size.

!

!

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents QUESTIONS? Contact the Store Where YOU Purchased this PROD- UCTModel No. WMTL19408 Serial No Version No Table of Contents Assembly on page 6 and HOW to Fold Important PrecautionsTreadmill until it is properly assembled. See Page HOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Pin is resting securely against the catchAssembly Wheels should turn freely Repeat this step on the left side of the treadmillPlastic Diagram of the Console Insert the key fully into the consoleHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt When you are finished exercising, remove From the console and unplug the power cord. NextHeight and that both incline pins are fully inserted Monitor your progress with the displayBefore YOU Begin For your benefit, read this manual carefully beforeMaintenance and Troubleshooting Problem The power turns off during useProblem Solution Walking belt slows when walked onKey and Unplug the Power CORD. Using Walking belt. If the walking belt has shifted toExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart Identification Chart R0908A QtyDescription Qty DescriptionExploded Drawing Ordering Replacement Parts
Top Page Image Contents