Weslo WMTL19408 user manual Assembly

ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Do not remove the long wire is inside the Right
Handrail until told to. Note: The underside of the treadmill walking belt is coated with high-performance lubricant.
During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping car-
ton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the
lubricant with a soft cloth and a mild, non-abrasive cleaner.							, adjustable
Assembly requires the included hex key		.	and your own Phillips screwdriver
wrench	, and wire cutters
Note: To identify small parts used during assembly, see the PART IDENTIFICATION CHART in the center of
this manual. Some parts may be preassembled. To avoid damaging plastic parts, do not use power tools
for assembly.
1. Attach the six Base Pads (19) to the bottom of the Base				1
(71) with six Base Pad Screws (42). Note: The Base					42	71	42
Pads may be preassembled.									4219
	!				19		19
	!				42	4219
					19
2. Have a second person hold the Base (71) in the position				2	30
shown.							17
Identify the Right Handrail (6) which has a large hole near					12
the lower end.									3017
Hold the Right Handrail (6) so that the bend is in the							Large	12
position shown. Insert two Handrail Bolts (12) into the
bracket on the Right Handrail. Attach the Right Handrail							Hole
to the Base (71) with the Handrail Bolts, two Handrail					7				30
Washers (30) and two Nuts (17). Do not tighten the
Nuts yet.						6
Attach the Left Handrail (7) to the Base (71) in the same							71
way.					Bend
			6