8.Carefully lower the Handrails (6, 7) to the floor. Center the Frame (55) between the Handrails, and tighten the four Handrail Bolts (12). Then, raise the Handrails to the verti- cal position.
See drawing 8a. Attach the Latch Assembly (41) to the Left Handrail (7) with two 16mm Screws (58). Make sure that the Latch Assembly is oriented as shown.
See HOW TO CHANGE THE INCLINE OF THE TREAD- MILL on page 13. Adjust the incline legs and insert the incline pins into the incline legs.
8 |
12 |
55 |
6, 7 |
8a |
58 |
7 |
41 |
9.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 17). To protect the floor or carpet, place a mat under the treadmill.
9