Weslo WLTL19323 Hold the Console 1 near the Console Plate, Handrail 16 to discharge any static

Page 7

6. Hold the Console (1) near the Console Plate (4).

Touch

the Handrail (16) to discharge any static.

 

Locate the two wires in the Wire Harness (22) that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the switch shown in inset drawing 6a. Connect the other two wires in the Wire Harness to the back of the Console (1) in the locations shown by the

arrows in drawing 6. If the connectors do not fit to- gether easily , rotate them and then connect them.

Set the Console (1) on the Console Plate (4).

IMPORTANT: Keep the Wire Harness (22) away from the battery access opening and the bosses shown above. Make sure that no wires are pinched before

you attach the Console (1) to the Console Plate (4).

Finger tighten the five 3/4” Screws (65) into the Console

Plate (4) and the Console (1).

IMPORTANT: Make sure

no wires are damaged by the Screws.

After all five

Screws have been started, firmly tighten them.

7.Attach a Wheel (15) to each side of the Base (28) with a Wheel Bolt (14) and a Nut (29).

6

 

 

1

Boss

Boss

Battery

4

Access

22

16

 

 

65

6a

 

Tabs

 

7

 

 

28

29

15

 

 

14

8. Make sure that all parts used in assembly are properly tightened before you use the treadmill.

Keep the

included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To

 

protect the floor or carpet, place a mat under the treadmill.

 

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents QUESTIONS? To Avoid DELAYS, Please Call Direct to OUR TollCustomer HOT Line Important Precautions Table of ContentsTreadmill on page 11. You must be Treadmill is capable of high speedsDecals shown have been placed on For your benefit, read this manual carefully before Before YOU Begin Left Side Until is completed AssemblyAssembly requires two persons Do notWith two Handrail Bolts 12 and two Washers Wire HarnessBracket Vertical positionPlate 4 and the Console Hold the Console 1 near the Console PlateHandrail 16 to discharge any static You attach the Console 1 to the Console PlatePerformant Lube HOW to Plug in the Power CordThis product must be grounded.If it should malfunc Tab Diagram of the ConsoleAdjust the speed in small increments Step -BY -STEP Console OperationHOW to Change the Incline of the Treadmill HOW to Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Lower the Treadmill for USE Power Cord Maintenance and TroubleshootingBelt has shifted to the left Problem The walking belt slows when walked onSolution Come damaged. Remove the keyWorkout Guidelines HOW to Measure Your Heart RateConditioning Guidelines Exercise IntensitySuggested Stretches Exercise FrequencyPart Identification Chart Circuit Breaker DescriptionR0703A Part No R0703A Ordering Replacement PartsLimited Warranty Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT
Top Page Image Contents