Weslo WLTL19323 user manual Bracket, Wire Harness, Vertical position, Hinges in the position shown

3. Make sure that the treadmill is on its left side.

3

22

If there are plastic ties in the three holes indicated by the

arrows, remove them. Hold the Handrail (16) near the

Right Upright (6) as shown. Insert the Wire Harness (22)

up through the bracket on the Handrail and out of the

round hole in the center of the Handrail. If necessary, use

Bracket

16

6

needlenose pliers to pull the Wire Harness out of the

hole. Be careful not to damage the Wire Harness.

Insert the brackets on the Handrail into the Uprights.

Remove the tape from the connectors on the end of the

Wire Harness (22).

With the help of a second person, raise the treadmill to

the vertical position.

4. Loosely attach the Handrail (16) to the Uprights (6, 17)

with two Handrail Bolts (12) and two Washers (11).

Loosely attach the Console Plate (4) to the Handrail (16) with two Console Bolts (79) and two Washers (11). Insert the Battery Cover (8) into the Console Plate, with the

hinges in the position shown.

Have a second person raise the treadmill frame to the vertical position (see drawing 1 of HOW TO FOLD THE

TREADMILL FOR STORAGE on page 11).While the frame is being held, tighten the bolts used in steps 1, 2, and 4. Make sure that no part of the treadmill rubs on

the treadmill frame when it is lowered and raised.

5.Carefully raise the Frame (55) to the vertical position. Attach the Storage Latch (77) to the Frame with three 3/4” Screws (65).

Connectors

22

17

4		4
16
		Hinges
		8
	12
11	11
		79 11
17		79
		12
		11
		6
5
	55
		77
65

6