8.Insert the wires into the Right Upright (78). Next, insert the brackets on the console assembly into the Right Upright and the Left Upright (77). Be careful not to pinch any wires.
Attach the console assembly with four 5/16" x 3/4" Screws (2) and four 5/16" Star Washers (5).
Start all four Screws, and then firmly tighten them.
9.Set the Left Handrail (69) and the Right Handrail (71) on a level surface.
Attach the Handrails (69, 71) to the Handrail Bracket (70) with four 1/4" x 1 1/2" Bolts (3) and four 1/4" Nuts (4). See the lower drawing.
Make sure that the Nuts sit inside the indi- cated square holes in the Handrails. Start all four Bolts, and then tighten them.
10.Hold the Pulse Assembly (72) near the Handrail Bracket (70). Orient the Pulse Assembly so that the indicated plastic post will fit into the hole in the Right Handrail (71). Connect the two Pulse Ground Wires (86) to the ground wires on the Pulse Assembly.
Next, insert the wire harness on the Pulse Assembly (72) into the top of the Handrail Bracket (70) and pull it out of the side as shown.
Set the Pulse Assembly (72) on the Handrails (69, 71). Insert the excess ground wire into the Handrails. Attach the Pulse Assembly with four #8 x 3/4" Screws (7). Be careful not to over- tighten the Screws. Be careful not to pinch any wires.
8 |
|
|
|
|
| Console |
|
|
|
|
|
| |
|
|
|
|
|
| Assembly |
2 |
|
|
|
|
| 2 |
|
|
|
|
|
| |
5 |
| 5 |
| 2 | 2 | 5 |
|
|
|
| |||
78 |
|
|
|
|
| 77 |
9 | 3 |
|
| 3 |
|
|
71 |
|
| 69 |
| ||
|
|
|
|
| ||
4 | 70 |
|
| 4 |
|
|
71 |
|
| Square Holes | 69 | ||
4 |
|
|
|
|
| 4 |
10 |
|
|
| Pulse |
|
|
Post |
|
| 72 |
| ||
86 | Wires |
| ||||
|
|
| ||||
71 |
|
|
|
|
| 69 |
7 | 70 | 7 |
Wire Harness |
|
10