TROUBLESHOOTING
Most treadmill problems can be solved by follow- ing the simple steps below. Find the symptom that applies, and follow the steps listed. If further assis- tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a.Make sure that the power cord is plugged into a surge suppressor and that the surge suppressor is plugged into a properly grounded outlet (see page 13). Use only a surge suppressor that meets all of the specifications described on page 13.
IMPORTANT: The treadmill is not compatible with
b.After the power cord has been plugged in, make sure that the key is inserted into the console.
c.Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in.
c
Tripped | Reset |
SYMPTOM: The power turns off during use
a.Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.
b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c.Remove the key from the console, and then reinsert it.
d.If the treadmill still will not run, please see the front cover of this manual.
SYMPTOM: The console displays remain lit when you remove the key from the console
a.The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 18 to turn off the demo mode.
SYMPTOM: The displays of the console do not function properly
a.Remove the key from the console and UNPLUG THE POWER CORD. Next, remove the two #12 x 1 1/4" Screws (27) and the two #8 x 3/4" Hood Screws (24) and carefully remove the Motor Hood (62).
a | 24 |
62 | |
27 | 27 |
|
Locate the Reed Switch (46) and the Magnet (44) on the left side of the Pulley (43). Turn the Pulley until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If necessary, loosen the #8 x 3/4" Tek Screw (20), move the Reed Switch slightly, and then retighten the Screw. Reattach the Motor Hood (not shown), and run the treadmill for a few minutes to check for a correct speed reading.
1/8 in. | 43 |
20 |
|
46 | 44 |
Top
View
20