Weslo R 7.2 user manual HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill

Page 19

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL

To avoid damaging the treadmill, adjust the incline to the lowest position before you fold the treadmill. Then, remove the key and unplug the power cord.

CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow below. CAUTION: Do not hold the frame by the plastic foot rails. Bend your legs and keep your back straight. Raise the frame about halfway to the vertical position.

1

Frame

HOW TO MOVE THE TREADMILL

Before moving the treadmill, fold it as described at the left. CAUTION: Make sure that the latch pin is fully inserted into the platform cushion. Moving the treadmill may require two people.

1.Hold the frame and one of the handrails, and place one foot against a wheel.

1

Frame

Handrail

Wheel

2.Hold the treadmill firmly with your right hand as shown. Pull the latch knob to the left and hold it. Raise the frame until the hole in the platform cushion is aligned with the latch pin. Then, slowly release the latch knob; make sure that the latch pin is fully inserted into the platform cushion.

2

 

Latch

Engaged

Knob

 

Platform Cushion

 

To protect the floor or carpet, place a mat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the storage position in temperatures above 85° F (30° C).

2.Pull back on the handrail until the treadmill will roll on the wheels, and carefully move it to the desired location. CAUTION: Do not move the treadmill without tipping it back, do not pull on the frame, and do not move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill.

HOW TO LOWER THE TREADMILL FOR USE

1.See drawing 2. Hold the upper end of the treadmill with your right hand as shown. Pull the latch knob to the left and hold it. Next, lower the frame until it is past the latch pin. Then, release the latch knob.

2.See drawing 1 at the left. Hold the metal frame firmly with both hands, and lower it to the floor.

CAUTION: Do not hold the frame by the plastic foot rails, and do not drop the frame. Bend your legs and keep your back straight.

19

Image 19
Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. WLTL39712.0 Serial No Call TOLL-FREETable of Contents Important Precautions Page Before YOU Begin Assembly Attach the other Wheel 84 in the same way See the left inset drawing. Identify the two See the far right drawing. Tie the wire tieMake sure that the end of the Upright Wire Does not fall into the Right UprightPage Start all four Screws, and then firmly tighten them Nectors PROPERLY, the Console MAY Become Damaged When YOU Turn on PowerSide View View from Above HOW to Connect the Power Cord Operation and AdjustmentUse a Surge Suppressor Features of the Console Console DiagramInsert the key into the console HOW to Turn on the PowerHOW to USE the Manual Mode Select the manual modeFollow your progress with the displays Change the incline of the treadmill as desiredMeasure your heart rate if desired See on HOW to USE a Preset ApplicationSelect a preset application When you are finished exercising, removeInformation Mode HOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillSymptom The power turns off during use TroubleshootingSymptom The walking belt slows when walked on Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part ListExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT