Weslo R 7.2 user manual Nectors PROPERLY, the Console MAY, Become Damaged When YOU Turn on Power

11.	Hold the handrail assembly near the console	11
	assembly. Connect the wire harness extending
		Console
	from the handrail assembly to the wire har-
	ness extending from the console assembly. See	Assembly
	the inset drawing in step 7. The connectors
	should slide together easily and snap into			Wire
	place. If they do not, turn one connector and try
	again. IF YOU DO NOT CONNECT THE CON-		Harnesses
	NECTORS PROPERLY, THE CONSOLE MAY				Slot
	BECOME DAMAGED WHEN YOU TURN ON
	THE POWER.	69
	Set the Handrail Bracket (70) in the slot in the
	console assembly as you slide the ends of the	Bracket		70
	Handrails (69, 71) onto the brackets on the			Handrail
	Uprights (77, 78). Be careful not to pinch any
		77		Assembly
	wires.
				71
					78
					Bracket
12.	Partially tighten two 1/4" x 1 1/2" Bolts (3)	12
	with two 1/4" Washers (31) and two 1/4" Star
	Washers (11) into the Console Frame (92) and
	the Handrail Bracket (not shown). Do not fully
	tighten the Bolts yet.
	Next, partially tighten four 1/4" x 1/2" Screws (6)		11	92
	with four 1/4" Star Washers (11) into the lower
	ends of the Handrails (69, 71).	31		31
	Press the lower ends of the Handrails (69, 71)
		71			69
	against the Uprights (77, 78) as you tighten the
	four 1/4" x 1/2" Screws (6). Then, tighten the		3
	1/4" x 1 1/2" Screws (3).
		11			11
		6		77	6
		78

11