4.Change the incline of the treadmill as desired. To change the incline of the treadmill, press the Incline increase and decrease buttons. Each time you press a button, the incline setting will change by 0.5 percent; if you hold down a button, the in- cline setting will change quickly.
5.Follow your progress with the displays. The
represents a distance of 1/4 mile (402 meters). As you walk or run on the treadmill, the indica- tors around the track
will appear in succession until the entire track ap- pears. The track will then disappear and the indica- tors will again begin to appear in succession.
The left
burned. The left display will also show the incline of the treadmill each time the incline level changes. The display also shows your heart rate when you use the pulse sensor (see step 5 on this page). Note: When you use a preset workout, the left dis- play will show the time remaining in the workout in- stead of the elapsed time.
The right display— The right display can show the speed of the walking belt and the distance that you have walked or run.
To reset the displays, press the Stop button, re- move the key, and then reinsert the key.
6.Measure your heart rate if desired.
To measure your heart rate, stand on the foot rails and place your thumb on the pulse sensor (see the drawing on page 10). Do not press too hard, or the circulation in your thumb will be re- stricted and your pulse may not be detected. When your pulse is detected, the small heart sym- bol in the left display will flash and your heart rate will be shown. For the most accurate heart rate reading, hold your thumb on the pulse sensor for at least 15 seconds.
If the displayed heart rate appears to be too high or too low, or if your heart rate is not displayed, lift your thumb for a few seconds, and then reposition your thumb on the pulse sensor. Remember to stand still while measuring your heart rate.
7.When you are finished exercising, remove the key from the console.
Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest set- ting or you may damage the treadmill when you fold it to the storage position. Next, remove the key from the console and put it in a secure place. When you are finished using the treadmill, press the power switch into the off position and unplug the power cord. IMPORTANT: If you do not do this, the treadmillʼs electrical components may wear prematurely.
12