Weslo WETL49710.0 user manual Walking belt. If the walking belt has shifted to

Page 18

PROBLEM: The walking belt is off-center or slips when walked on

 

SOLUTION: a. If the walking belt has shifted to the left, first re-

a

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn the left idler roller bolt clock-

 

wise 1/2 of a turn. Be careful not to overtighten the

 

walking belt. If the walking belt has shifted to the

 

right, turn the left idler roller bolt counterclockwise 1/2

 

of a turn. Then, plug in the power cord, insert the key,

 

and run the treadmill for a few minutes. Repeat until

 

the walking belt is centered.

 

b. If the walking belt slips when walked on, first re-

b

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn both idler roller bolts clock-

 

wise, 1/4 of a turn. When the walking belt is correctly

 

tightened, you should be able to lift each edge of the

 

walking belt 2 to 3 in. (5 to 7 cm) off the walking plat-

 

form. Be careful to keep the walking belt centered.

 

Then, plug in the power cord, insert the key, and care-

 

fully walk on the treadmill for a few minutes. Repeat

 

until the walking belt is properly tightened.

 

PROBLEM: The incline of the treadmill does not change correctly

 

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re-

move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the

maximum incline level and then return to the minimum level. This will recalibrate the incline system.

18

Image 18
Contents QUESTIONS? Model No. WETL49710.0 Serial NoTable of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unpluggedStart all four Bolts, and then tighten each Them Become Damaged When YOU Turn on 19mm Screws 3. Be careful not to pinch WiresBolts, and then tighten each of them Page PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord AustraliaConsole Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Measure your heart rate if desired HOW to USE a Preset Workout Select one of the six preset workoutsInformation Mode HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Top ViewWalking belt. If the walking belt has shifted to Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart LIST-Model No. WETL49710.0 Key No. Qty DescriptionExploded Drawing A-Model No. WETL49710.0 R0610A Exploded Drawing B-Model No. WETL49710.0 R0610A Exploded Drawing C-Model No. WETL49710.0 R0610A Ordering Replacement Parts Recycling Information