Assembly

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver			, standard
screwdriver	, and needlenose pliers	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. To avoid dam- aging parts, do not use power tools for assembly. Extra hardware may be included.

4.2 x 19mm	#10 x 1" Tek
Screw (3)–6	Screw (83)–2
M10 x 45mm Bolt (2)–4	M10 x 65mm Bolt (1)–4
1. Make sure that the power cord is unplugged.	1	80
With the help of a second person, carefully tip		80
the treadmill onto its left side. Unfold the Frame	73
(50) away from the Uprights (73). Do not lean on	73
the Uprights.	50
Orient the Base (80) as shown. Attach the Base		1
to the Uprights (73) with four M10 x 65mm Bolts		1
(1). Start all four Bolts, and then tighten each
of them.
Raise the Uprights (73), so that the Base (80) is
flat on the floor.
		1
	6

ASSEMBLY

1. Make sure that the power cord is unplugged.

(1). Start all four Bolts, and then tighten each

of them.