Frame Assembly
1.Before beginning, make sure that you have read and understood the information on page 4.
Open the parts bag labeled “FRAME ASSEMBLY.”
Press a 2” Square Inner Cap (28) into each end of the Butterfly Base (4) and into the indicated locations on the Weight Base (5).
Insert four 5/16” x 2 1/2” Carriage Bolts (92) and a 3/8” x 3 3/4” Carriage Bolt (85) into the indicated holes in the Butterfly Base (4). Place the Butterfly Base flat on the floor. Note: If the Bolts fall out, secure them by putting a piece of tape over the head of each Bolt.
2.Attach the Weight Base (5) to the Butterfly Base (4) with two 5/16” x 2 3/4” Bolts (89), a Support Plate (94), and two 5/16” Nylon Locknuts (64).
3.Press a 2” Square Inner Cap (28) into each end of the Press Base (6). Turn the Press Base so the indi- cated welded tube is near the top.
Insert four 5/16” x 2 1/2” Carriage Bolts (92) and a 3/8” x 4” Carriage Bolt (104) into the indicated holes in the Press Base (6). Note: The 3/8” x 4” Carriage
Bolt will be tipped at an angle.
4.Attach the Press Base (6) to the Weight Base (5) with two 5/16” x 2 3/4” Bolts (89), a Support Plate (94), and two 5/16” Nylon Locknuts (64).
1 |
|
| 28 |
|
|
| |
|
|
| 28 |
| 4 |
| 28 |
|
|
| 85 |
|
| 92 | 5 |
|
|
| |
| 92 |
|
|
28 |
|
|
|
2 | 89 |
|
|
|
|
| |
| 94 |
| 64 |
| 4 |
| 64 |
|
|
| 5 |
3 |
|
| 28 |
|
|
| |
|
| 6 |
|
| Welded |
|
|
| Tube |
| 104 |
|
|
| |
28 |
|
|
|
|
|
| 92 |
| 92 |
|
|
4 |
|
|
|
|
|
| 64 |
| 5 |
|
|
|
| 64 | 94 |
|
|
| |
| 6 |
|
|
|
|
| 89 |
5
