8.Place two Weight Bumpers (51) over the indicated holes in the Weight Base (5). Slide a Weight Guide
(15)into each of the holes.
Attach the indicated Weight Guide (15) to the Weight Base (5) with a 3/8” x 2 3/4” Bolt (46), two 3/8” Flat Washers (48), and a 3/8” Nylon Locknut (50).
Slide twelve Weights (21) onto the Weight Guides (15). Make sure the Weights are turned so the pin grooves are on the bottom.
Identify the Long Weight Tube (96), which has twelve holes in it. Press a Weight Tube Bumper (18) into the lower end of the Long Weight Tube. Slide the Weight Tube into the Weights (21).
Slide a Top Weight (16) onto the Weight Guides (15).
Make sure the Top Weight is turned so the groove fits over the pin on the Long Weight Tube (96).
9.Place the Weight Top Frame (66) on the indicated brackets on the Uprights (1, 2). Note: When attach- ing the Weight Top Frame make sure that the tops of both Weight Guides (15) are in back of the Top Frame, as shown in step 10.
Attach the Weight Top Frame (66) to each Upright (1,
2)with two 3/8” x 2 3/4” Bolts (46), a Small Support Plate (26), and two 3/8” Nylon Locknuts (50).
Tighten all of the Nylon Locknuts (64) used in steps 5 and 6.
10.Press three 2” Square Inner Caps (28) into the Butterfly Top Frame (33).
Attach the Butterfly Top Frame (33) to the brackets on the Butterfly Upright (1) and the Weight Top Frame (66) with four 5/16” x 2 3/4” Bolts (89), two Support Plates (94), and four 5/16” Nylon Locknuts (64).
8
16
Groove 
|
| Pin | 96 |
|
|
| |
|
| Pin | 15 |
|
| Groove | 18 |
|
|
| |
|
|
| 21 |
|
|
| 51 |
|
|
| 50 |
|
| 5 | 48 |
|
|
| |
| 46 | 48 |
|
|
|
| |
9 | 46 |
|
|
|
|
| |
| 26 | 66 | 46 |
|
| ||
|
| 50 | 26 |
|
|
| |
|
| 15 |
|
| 1 |
|
|
|
| Bracket | 50 |
|
| 2 | |
|
|
| |
10 |
| 89 |
|
|
| 94 |
|
|
| 89 |
|
| 28 |
| 28 |
|
| 94 | 64 |
| 33 |
| 66 |
|
|
| |
|
| 28 |
|
|
| 64 | 1 |
7 |
|
|
|
