25.Attach the Butterfly Cable (73) to the bracket on the Right Butterfly Arm (11) with a 3/8” x 1” Bolt (84) and two 3/8” Nylon Jam Nuts (63). Note: Do not over- tighten the bottom Nylon Jam Nut; the Cable must pivot freely on the Bolt.
26.Identify the Ab Cable (74). It is the second longest cable and has a ball on one end and a bolt on the other.
Wrap the Ab Cable (74) around a 3 1/2” Pulley (24) in the direction shown. Place two Pulley Covers (47) over the Pulley, so that the large tabs are in the posi- tion shown. Attach the Pulley and Pulley Covers to the Butterfly Upright (1) with a 3/8” x 3 3/4” Bolt (59), two 3/8” Flat Washers (48), and a 3/8” Nylon Jam Nut (63). Make sure the Cable is between the Pulley and the welded pin on the Upright.
27.Remove both 3 1/2” Pulleys (24) from the second set of
Wrap the Ab Cable (74) around a 3 1/2” Pulley (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the top hole in the two Pulley Plates (23) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50). Make sure the Cable Trap is oriented as shown.
28.Wrap the Ab Cable (74) around a 3 1/2” Pulley (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the bottom hole in the first set of Pulley Plates (23) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50). Make sure that the Pulley Bracket and Cable Trap are oriented exactly as shown.
25 | 84 |
|
| |
|
|
| ||
11 |
|
|
| |
| 63 |
|
| |
|
| 73 |
| |
26 |
|
|
| |
63 |
| Large Tabs | ||
48 |
| |||
|
|
| ||
47 | 24 |
| 48 | |
| 47 | |||
|
| |||
|
|
| ||
| 74 |
| 59 | |
Welded Pin | ||||
| ||||
| 1 |
|
| |
27 |
|
|
| |
| Pulley |
| ||
| 74 |
|
| |
24 | 25 |
|
| |
54 |
|
|
| |
|
| 50 |
| |
| 23 |
| 1 | |
|
|
| ||
28 |
|
|
| |
| 1 |
|
| |
| 74 | 23 | 50 | |
|
|
| ||
23 |
| 25 | ||
|
|
| ||
|
| 54 | 24 | |
12
